When a malfunction is detected between various ECUs and sensors, these DTCs are stored.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | DTC Output from | Priority |
|---|---|---|---|---|---|
| U012587 | Lost Communication With Multi-axis Acceleration Sensor Module Missing Message | While the vehicle is being driven at 5 km/h (4 mph) or more, a communication error between the yaw rate sensor (airbag ECU assembly) and the forward recognition camera is detected for approximately 4 seconds or more. | CAN communication system | Pre-Collision System | B |
| U012687 | Lost Communication with Steering Angle Sensor Module Missing Message | 3 seconds after the ignition switch is turned to ON, a communication error between the steering sensor and the forward recognition camera is detected for approximately 1 second or more. | CAN communication system | Pre-Collision System | B |
| U012987 | Lost Communication with Brake System Control Module Missing Message | 3 seconds after the ignition switch is turned to ON, a communication error between the No. 2 skid control ECU (brake actuator assembly) and the forward recognition camera is detected for approximately 1 second or more. | CAN communication system | Pre-Collision System | B |
| U013187 | Lost Communication with Power Steering Control Module Missing Message | 3 seconds after the ignition switch is turned to ON, a communication error between the power steering ECU (rack and pinion power steering gear assembly) and the forward recognition camera is detected for approximately 2 second or more. | CAN communication system | Pre-Collision System | B |
| U029387 | Lost Communication with Hybrid/EV Powertrain Control Module Missing Message | While the vehicle is being driven at 5 km/h (4 mph) or more, a communication error between the EV control ECU and the forward recognition camera is detected for approximately 6 seconds or more. | CAN communication system | Pre-Collision System | B |
Pre-procedure1
None
Procedure1
Clear the DTCs.
| Proceed to |
|---|
| NEXT |
Post-procedure1
None
NEXT
Pre-procedure1
Reproduce the vehicle conditions that were present when the DTCs that were noted were stored.
If the detection conditions are not met, the system cannot detect malfunctions.
Procedure1
Check for DTCs.
| Result | Proceed to |
|---|---|
| DTCs are not output | A |
| DTCs are output | B |
Post-procedure1
None
A
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING
B
Click herePower Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM>HOW TO PROCEED WITH TROUBLESHOOTING