The EV control ECU communicates with each sensor and ECU via CAN communication.
If any malfunction is detected in a CAN communication circuit, one or more CAN communication system DTCs are stored.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | DTC Output from | Priority |
|---|---|---|---|---|---|
| U010487 | Lost Communication with Cruise Control Module Missing Message | When the ignition switch is ON and the dynamic radar cruise control system is operating, a communication malfunction between the forward recognition camera and EV control ECU is detected for approximately 1 second or more. | CAN communication system | Radar Cruise1 | B |
| U012287 | Lost Communication with Vehicle Dynamics Control Module Missing Message | When the ignition switch is ON and the dynamic radar cruise control system is operating, a communication malfunction between the No. 2 skid control ECU (brake actuator assembly) and EV control ECU is detected for approximately 2.6 seconds or more. | CAN communication system | Radar Cruise1 | B |
| U029387 | Lost Communication with Hybrid/EV Powertrain Control Module Missing Message | When the dynamic radar cruise control system is operating, a communication malfunction between the No. 2 skid control ECU (brake actuator assembly) and EV control ECU is detected for approximately 1 second or more. | CAN communication system | Radar Cruise1 | B |
Pre-procedure1
None
Procedure1
Clear the DTCs.
| Proceed to |
|---|
| NEXT |
Post-procedure1
None
NEXT
Pre-procedure1
Make sure that the DTC detection conditions are met.
If the detection conditions are not met, the system cannot detect the malfunction.
Procedure1
Check for DTCs.
| Result | Proceed to |
|---|---|
| DTCs are not output | A |
| DTCs are output | B |
Post-procedure1
None
A
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING
B
Click herePower Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM>HOW TO PROCEED WITH TROUBLESHOOTING