When a malfunction is detected between various ECUs and sensors, these DTCs are stored.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | DTC Output from | Priority |
|---|---|---|---|---|---|
| U012587 | Lost Communication With Multi-axis Acceleration Sensor Module Missing Message | After 3 seconds or more have elapsed since turning the lane tracing assist system on and the ignition switch to ON, while the vehicle speed is 5 km/h (3 mph) or more, a communication malfunction between the forward recognition camera and the G sensor (airbag ECU assembly) is continuously detected for 5 seconds or more | CAN communication system | Lane Control | B |
| U012687 | Lost Communication with Steering Angle Sensor Module Missing Message | After 3 seconds or more have elapsed since turning the lane tracing assist system on and the ignition switch to ON, a communication malfunction between the forward recognition camera and the steering sensor is continuously detected for 5 seconds or more | CAN communication system | Lane Control | B |
| U012987 | Lost Communication with Brake System Control Module Missing Message | After 3 seconds or more have elapsed since turning the lane tracing assist system on and the ignition switch to ON, a communication malfunction between the forward recognition camera and the No. 2 skid control ECU (brake actuator assembly) is continuously detected for 5 seconds or more | CAN communication system | Lane Control | B |
| U013187 | Lost Communication with Power Steering Control Module Missing Message | After 3 seconds or more have elapsed since turning the lane tracing assist system on and the ignition switch to ON, a communication malfunction between the forward recognition camera and the power steering ECU (rack and pinion power steering gear assembly) is continuously detected for 5 seconds or more | CAN communication system | Lane Control | B |
| U015587 | Lost Communication with Instrument Panel Cluster (IPC) Control Module Missing Message | After 3 seconds or more have elapsed since turning the lane tracing assist system on and the ignition switch to ON, a communication malfunction between the forward recognition camera and the combination meter assembly is continuously detected for 50 seconds or more | CAN communication system | Lane Control | B |
| U029387 | Lost Communication with Hybrid/EV Powertrain Control Module Missing Message | After 3 seconds or more have elapsed since turning the lane tracing assist system on and the ignition switch to ON, while the vehicle speed is 5 km/h (3 mph) or more, a communication malfunction between the forward recognition camera and the EV control ECU is continuously detected for 5 seconds or more | CAN communication system | Lane Control | B |
Pre-procedure1
None
Procedure1
Clear the DTCs.
| Proceed to |
|---|
| NEXT |
Post-procedure1
None
NEXT
Pre-procedure1
Reproduce the vehicle conditions that were present when the DTCs that were noted were stored.
If the detection conditions are not met, the system cannot detect malfunctions.
Procedure1
Check for DTCs.
| Result | Proceed to |
|---|---|
| DTCs are not output | A |
| DTCs are output | B |
Post-procedure1
None
A
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING
B
Click herePower Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM>HOW TO PROCEED WITH TROUBLESHOOTING