Home › Drivetrain › DRIVE SHAFT / PROPELLER SHAFT › REAR DRIVE SHAFT ASSEMBLY
RM37H0E _52 Drivetrain _097407 DRIVE SHAFT / PROPELLER SHAFT _0455866 REAR DRIVE SHAFT ASSEMBLY G

DRIVE SHAFT / PROPELLER SHAFT  REAR DRIVE SHAFT ASSEMBLY  INSPECTION  


CAUTION / NOTICE / HINT

NOTICE:
·

When using a vise, place aluminum plates between the part and vise.

·

When using a vise, do not overtighten it.



PROCEDURE

Hide 1.INSPECT REAR DRIVE SHAFT ASSEMBLY

a.
C385073

Check that the inboard joint and outboard joint slides smoothly in the thrust direction.


b.

Check that there is no excessive play in the radial direction of the inboard joint and outboard joint.


c.

Check the inboard joint boot and outboard joint boot for damage.


d.
C385074N01
1.844,1.667 2.115,1.906 0.271,0.24 10 false (A)

Check that the inboard joint boot and outboard joint boot are not stretched or contracted when the rear drive shaft assembly is at the standard length.

Length (A):
Item Specified Condition
LH Side 690.0 mm
2.263 ft.
RH Side 771.0 mm
2.529 ft.


NOTICE:

Keep the rear drive shaft assembly level during inspection.


If the inboard joint boot and outboard joint boot are stretched or contracted, correct them.