Home › Suspension › FRONT SUSPENSION › FRONT LOWER SUSPENSION ARM
RM37H0E _53 Suspension _097405 FRONT SUSPENSION _0455869 FRONT LOWER SUSPENSION ARM G

FRONT SUSPENSION  FRONT LOWER SUSPENSION ARM  INSPECTION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH and LH side.

·

The following procedure is for the LH side.



PROCEDURE

Hide 48640 1.INSPECT FRONT LOWER SUSPENSION ARM ASSEMBLY LH

a.
C448112

Inspect the turning torque of the ball joint.

i.

Install the nut to the front lower suspension arm assembly LH stud.


ii.

Using a torque wrench, turn the stud continuously at a rate of 2 to 4 seconds per turn and take the torque reading on the 5th turn.

Turning torque:
Specified Condition
0.5 to 3.4 N*m
6 to 34 kgf*cm
5 to 30 in.*lbf


If the turning torque is not within the specified range, replace the front lower suspension arm assembly LH with a new one.



b.

Inspect the dust cover.

i.

Check that the dust cover is not cracked and that there is no grease on it.

If the dust cover is cracked or there is grease on it, replace the front lower suspension arm assembly LH with a new one.



Hide 48670A 2.INSPECT LOWER NO. 2 SUSPENSION ARM ASSEMBLY LH

a.
C448113

Inspect the turning torque of the ball joint.

i.

Install the nut to the lower No. 2 suspension arm assembly LH stud.


ii.

Using a torque wrench, turn the stud continuously at a rate of 2 to 4 seconds per turn and take the torque reading on the 5th turn.

Turning torque:
Specified Condition
1.0 to 3.0 N*m
11 to 30 kgf*cm
9 to 26 in.*lbf


If the turning torque is not within the specified range, replace the lower No. 2 suspension arm assembly LH with a new one.



b.

Inspect the dust cover.

i.

Check that the dust cover is not cracked and that there is no grease on it.

If the dust cover is cracked or there is grease on it, replace the lower No. 2 suspension arm assembly LH with a new one.