Home › Suspension › FRONT SUSPENSION › FRONT LOWER BALL JOINT
RM37H0E _53 Suspension _097405 FRONT SUSPENSION _0455870 FRONT LOWER BALL JOINT G

FRONT SUSPENSION  FRONT LOWER BALL JOINT  INSPECTION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH and LH side.

·

The following procedure is for the LH side.



PROCEDURE

Hide 43340A 1.INSPECT FRONT LOWER BALL JOINT ASSEMBLY LH

a.
C385136

Inspect the turning torque of the front lower ball joint.

i.

Secure the front lower ball joint assembly in a vise using aluminum plates.


ii.

Install the nut to the front lower ball joint stud.


iii.

Using a torque wrench, turn the stud continuously at a rate of 3 to 5 seconds per turn and take the torque reading on the 5th turn.

Turning torque:
Specified Condition
0.5 to 6.0 N*m
6 to 61 kgf*cm
5 to 53 in.*lbf


HINT:

If the turning torque is not within the specified range, replace the front lower ball joint assembly with a new one.




b.

Inspect the dust cover.

i.

Check that the dust cover is not cracked and that there is no grease on it.

HINT:

If the dust cover is cracked or there is grease on it, replace the front lower ball joint assembly with a new one.