Home › Suspension › REAR SUSPENSION › TOE CONTROL LINK
RM37H0E _53 Suspension _097406 REAR SUSPENSION _0455876 TOE CONTROL LINK G

REAR SUSPENSION  TOE CONTROL LINK  INSPECTION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH and LH side.

·

The following procedure is for the LH side.



PROCEDURE

Hide 48706B 1.INSPECT TOE CONTROL LINK SUB-ASSEMBLY LH

a.
C371633

Inspect the turning torque of the ball joint.

i.

Install the nut to the toe control link sub-assembly LH stud.


ii.

Using a torque wrench, turn the stud continuously at a rate of 2 to 4 seconds per turn and take the torque reading on the 5th turn.

Turning torque:
Specified Condition
0.9 to 3.5 N*m
10 to 35 kgf*cm
8 to 30 in.*lbf


If the turning torque is not within the specified range, replace the toe control link sub-assembly LH with a new one.



b.

Inspect the dust cover.

i.

Check that the dust cover is not cracked and that there is no grease on it.

If the dust cover is cracked or there is grease on it, toe control link sub-assembly LH with a new one.