Home › Suspension › REAR SUSPENSION › REAR STABILIZER BAR
RM37H0E _53 Suspension _097406 REAR SUSPENSION _0455877 REAR STABILIZER BAR G

REAR SUSPENSION  REAR STABILIZER BAR  INSPECTION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH and LH side.

·

The following procedure is for the LH side.



PROCEDURE

Hide 48840A 1.INSPECT REAR STABILIZER LINK ASSEMBLY LH

a.
C371638

Inspect the turning torque of the ball joint.

i.

Install the nut to the rear stabilizer link assembly LH stud.


ii.

Using a torque wrench, turn the stud continuously at a rate of 3 to 5 seconds per turn and take the torque reading on the 5th turn.

Turning torque:
Specified Condition
0.05 to 1.96 N*m
1 to 19 kgf*cm
1 to 17 in.*lbf


If the turning torque is not within the specified range, replace the rear stabilizer link assembly LH with a new one.



b.

Inspect the dust cover.

i.

Check that the dust cover is not cracked and that there is no grease on it.

If the dust cover is cracked or there is grease on it, replace the rear stabilizer link assembly LH with a new one.