DATA LIST
Read the Data List according to the display on the GTS.
| Tester Display | Measurement Item | Range | Normal Condition | Diagnostic Note |
|---|---|---|---|---|
| FL Seat A/C and Heater Sensitivity Adjust | Function to change sensitivity of the seat climate control system | -2 / -1 / 0 / +1 / +2 | Customized value displayed | - |
| FR Seat A/C and Heater Sensitivity Adjust | Function to change sensitivity of the seat climate control system | -2 / -1 / 0 / +1 / +2 | Customized value displayed | - |
| Seat Blast Mode Setting | Function to decrease the airflow volume of the seat blower in each mode | Standard / Silent (Wind Amount Hi) / Silent (Wind Amount Low) | Customized value displayed | - |
ACTIVE TEST
Using the GTS, perform Active Tests allows relays, VSVs, actuators and other items to be operated without removing any parts. This non-intrusive functional inspection can be very useful because intermittent operation may be discovered before parts or wiring is disturbed. Performing Active Tests early in troubleshooting is one way to save diagnostic time. Data List information can be displayed while performing Active Tests.
Perform the Active Test according to the display on the GTS.
| Tester Display | Measurement Item | Control Range | Diagnostic Note |
|---|---|---|---|
| Front Right Seat Blower | Front seat RH side seat climate control operation | OFF/ON | - |
| Front Left Seat Blower | Front seat LH side seat climate control operation | OFF/ON | - |
| Rear Right Seat Blower | Rear seat RH side seat climate control operation | OFF/ON | - |
| Rear Left Seat Blower | Rear seat RH side seat climate control operation | OFF/ON | - |