Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › ELECTRONICALLY CONTROLLED BRAKE SYSTEM
RM37H0E _54 Brake _096746 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0459129 ELECTRONICALLY CONTROLLED BRAKE SYSTEM C

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  ELECTRONICALLY CONTROLLED BRAKE SYSTEM  C145151  High Pressure Tube Air Bleeding Not Programmed  


DESCRIPTION

If air bleeding has not been performed, the No. 1 skid control ECU (brake booster with master cylinder assembly) stores DTC C145151 to prevent the entry of air due to pump motor operation.

DTC C145151 is stored when Motor Deactivate is selected, the system will not return to normal until the air bleeding procedure is performed.

DTC No. Detection Item DTC Detection Condition Trouble Area DTC Output from Priority Note
C145151 High Pressure Tube Air Bleeding Not Programmed Either of the following is detected:
·

Using the GTS, "Motor Deactivate" of the "ECB Utility" has been performed.

·

The brake booster with master cylinder assembly has been replaced.


Air bleeding not performed Brake Booster A Output ECU: No. 1 skid control ECU (brake booster with master cylinder assembly)
HINT:
·

The DTC is cleared when the conditions return to normal.

·

ECB: Electronically Controlled Brake System




C145151 DTC Detection Conditions
Vehicle Condition
Pattern 1 Pattern 2
Diagnosis Condition - - -
Malfunction Status Using the GTS, "Motor Deactivate" of the "ECB Utility" has been performed ○ -
The brake booster with master cylinder assembly has been replaced - ○
Detection Time - -
Number of Trips 1 trip 1 trip

HINT:

DTC will be output when conditions for either of the patterns in the table above are met.


PROCEDURE

1.PERFORM AIR BLEEDING
a.

Bleed the air from the brake system.

HINT:

Click hereBrake>BRAKE SYSTEM (OTHER)>BRAKE FLUID>BLEEDING


HINT:

If air bleeding has been performed, this DTC will be cleared.



Result:
Proceed to
NEXT



NEXT

2.RECONFIRM DTC
2.RECONFIRM DTC

Pre-procedure1

a.

Based on the Freeze Frame Data and interview with the customer, attempt to reproduce the conditions when the malfunction occurred.


Procedure1

a.

Check if the same DTC is output.

Chassis > Brake Booster > Trouble Codes
50001 466
Result:
Result Proceed to
C145151 is not output A
C145151 is output B



Post-procedure1

a.

None



A

END

B

PERFORM AIR BLEEDING AGAIN