These DTCs are stored when a malfunction occurs in the radio and display receiver assembly.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | DTC Output from | Priority |
|---|---|---|---|---|---|
| B158D | Video Signal Stoppage | The internal video signal of the radio and display receiver assembly is interrupted | Radio and display receiver assembly | Navigation System | A |
| B15A0 | LAN Master Malfunction | When either of the following conditions is met:
·
Bus malfunction ·
EEPROM error |
Radio and display receiver assembly | Navigation System | A |
| B15B0 | Display Screen Malfunction | Picture circuit (TFT unit) malfunction | Radio and display receiver assembly | Navigation System | A |
| B15B3 | Radio Tuner Malfunction | When any of the following conditions is met:
·
AM tuner PLL is unlocked ·
FM tuner PLL is unlocked ·
Tuner malfunction |
Radio and display receiver assembly | Navigation System | A |
| B15B7 | Bluetooth Module Malfunction | "Bluetooth" module malfunction | Radio and display receiver assembly | Navigation System | A |
Pre-procedure1
Clear the DTCs.
Procedure1
Recheck for DTCs and check that no DTCs are output.
| Result | Proceed to |
|---|---|
| DTCs are not output | A |
| DTCs are output | B |
Post-procedure1
None
A
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING
B