Home › Audio / Visual / Telematics › AUDIO / VIDEO › AUDIO AND VISUAL SYSTEM
RM37H0E _56 Audio / Visual / Telematics _095260 AUDIO / VIDEO _0455059 AUDIO AND VISUAL SYSTEM C

AUDIO / VIDEO  AUDIO AND VISUAL SYSTEM  B158F  AV Signal Stoppage (Low Battery Voltage)  


DESCRIPTION

This DTC is stored when a video or audio signal is interrupted due to auxiliary battery voltage input to the radio and display receiver assembly dropping temporarily.

DTC No. Detection Item DTC Detection Condition Trouble Area DTC Output from Priority
B158F AV Signal Stoppage (Low Battery Voltage) A video or audio signal is interrupted when the auxiliary battery voltage drops
·

Radio and display receiver assembly

·

Harness or connector


Navigation System A

WIRING DIAGRAM

E397237E69
0.25,1 3.615,1.198 3.365,0.198 10 false from Auxiliary Battery 5.24,1 5.698,1.198 0.458,0.198 10 false +B1 5.094,0.906 5.25,1.104 0.156,0.198 10 false 4 4.781,1.896 5.167,2.115 0.385,0.219 10 false D54 4.781,2.063 6.49,2.646 1.708,0.583 10 false Radio and Display Receiver Assembly 3.385,1.198 4.063,1.458 0.677,0.26 10 false TV

CAUTION / NOTICE / HINT

NOTICE:

Inspect the fuse for circuits related to this system before performing the following procedure.


PROCEDURE

1.CHECK VEHICLE SIGNAL (OPERATION CHECK)

Pre-procedure1

a.
E268487

Enter the "Vehicle Signal Check Mode" screen. Refer to Check Vehicle Signal in Operation Check.

HINT:

Click hereAudio / Visual / Telematics>AUDIO / VIDEO>AUDIO AND VISUAL SYSTEM>OPERATION CHECK



Procedure1

b.

Measure the auxiliary battery voltage with the ignition switch off.

Standard voltage:

11 to 14 V


HINT:

This display is updated once per second.


Result:
Proceed to
OK
NG



Post-procedure1

c.

None



OK

2.CHECK DTC

NG

3.CHECK HARNESS AND CONNECTOR (RADIO AND DISPLAY RECEIVER ASSEMBLY POWER SOURCE)
2.CHECK DTC

Pre-procedure1

a.

Clear the DTCs.

Body Electrical > Navigation System > Clear DTCs
50002 212

Procedure1

b.

Recheck for DTCs and check that no DTCs are output.

Body Electrical > Navigation System > Trouble Codes
50001 212
Result:
Result Proceed to
DTCs are not output A
DTCs are output B



Post-procedure1

c.

None



A

END

B

REPLACE RADIO AND DISPLAY RECEIVER ASSEMBLY

3.CHECK HARNESS AND CONNECTOR (RADIO AND DISPLAY RECEIVER ASSEMBLY POWER SOURCE)

Pre-procedure1

a.

Disconnect the D54 radio and display receiver assembly connector.


Procedure1

b.

Measure the voltage according to the value(s) in the table below.

Standard Voltage:
Tester Connection Switch Condition Specified Condition

Click Location & Routing(D54)Location & Routing

Click Connector(D54)Instrument Panel>Instrument Panel Wire>Radio Receiver Assembly

D54-4 (+B1) - Body ground Ignition switch off 11 to 14 V


Result:
Proceed to
OK
NG



Post-procedure1

c.

None



OK

REPLACE RADIO AND DISPLAY RECEIVER ASSEMBLY

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR