Home › Audio / Visual / Telematics › AUDIO / VIDEO › AUDIO AND VISUAL SYSTEM
RM37H0E _56 Audio / Visual / Telematics _095260 AUDIO / VIDEO _0455059 AUDIO AND VISUAL SYSTEM C

AUDIO / VIDEO  AUDIO AND VISUAL SYSTEM  B15F7  Certification ECU Vehicle Information Reading/Writing Process Malfunction  


DESCRIPTION

This DTC is stored when items controlled by the certification ECU (smart key ECU assembly) cannot be customized via the audio and visual system vehicle customization screen.

HINT:

The certification ECU (smart key ECU assembly) controls the entry and start system related items that are customizable via the audio and visual system vehicle customization screen.


DTC No. Detection Item DTC Detection Condition Trouble Area DTC Output from Priority
B15F7 Certification ECU Vehicle Information Reading/Writing Process Malfunction Certification ECU (smart key ECU assembly) vehicle setting processing malfunction
·

CAN communication system

·

Entry and start system

·

Certification ECU (smart key ECU assembly)

·

Radio and display receiver assembly


Navigation System B

CAUTION / NOTICE / HINT

NOTICE:

Before replacing the certification ECU (smart key ECU assembly), refer to Service Bulletin.


PROCEDURE

1.CHECK CAN COMMUNICATION SYSTEM
a.

Use the GTS to check if the CAN communication system is functioning normally.

HINT:

Click herePower Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM>HOW TO PROCEED WITH TROUBLESHOOTING


OK:

CAN communication DTCs are not output.



Result:
Proceed to
OK
NG



OK

2.CHECK ENTRY AND START SYSTEM

NG

2.CHECK ENTRY AND START SYSTEM
a.

Check if the entry and start system is malfunctioning.

HINT:

for Entry Function: Click hereVehicle Interior>THEFT DETERRENT / KEYLESS ENTRY>ENTRY AND START SYSTEM (for Entry Function)>HOW TO PROCEED WITH TROUBLESHOOTING


HINT:

for Start Function: Click hereVehicle Interior>THEFT DETERRENT / KEYLESS ENTRY>ENTRY AND START SYSTEM (for Start Function)>HOW TO PROCEED WITH TROUBLESHOOTING


HINT:

Customization may not be possible depending on the malfunction in the entry and start system.


OK:

No malfunctions are present in the entry and start system.



Result:
Proceed to
OK
NG



OK

3.CHECK CUSTOMIZE ITEMS

NG

3.CHECK CUSTOMIZE ITEMS

Pre-procedure1

a.

Make a note of the customizable items for the certification ECU related system.

HINT:

The items shown as customizable via the audio and visual system vehicle customization screen can also be changed using the GTS. In the following step, the GTS will be used.


i.

To match-up the items on the audio and visual system vehicle customization screen with the items on the GTS, check the customize parameters list for the entry and start system related items that can be customized via the audio and visual system vehicle customization screen.

HINT:

for Entry Function: Click hereVehicle Interior>THEFT DETERRENT / KEYLESS ENTRY>ENTRY AND START SYSTEM (for Entry Function)>CUSTOMIZE PARAMETERS


HINT:

for Start Function: Click hereVehicle Interior>THEFT DETERRENT / KEYLESS ENTRY>ENTRY AND START SYSTEM (for Start Function)>CUSTOMIZE PARAMETERS




Procedure1

b.

Using the GTS, check that it is possible to change the settings of the customize parameters that are available for customization via the audio and visual system vehicle customization screen.

OK:

The items available for customization via the audio and visual system vehicle customization screen can be customized successfully using the GTS.


Result:
Proceed to
OK
NG



Post-procedure1

c.

None



OK

REPLACE RADIO AND DISPLAY RECEIVER ASSEMBLY

NG

REPLACE CERTIFICATION ECU (SMART KEY ECU ASSEMBLY)