Home › Audio / Visual / Telematics › AUDIO / VIDEO › AUDIO AND VISUAL SYSTEM
RM37H0E _56 Audio / Visual / Telematics _095260 AUDIO / VIDEO _0455059 AUDIO AND VISUAL SYSTEM J

AUDIO / VIDEO  AUDIO AND VISUAL SYSTEM  Touch Panel Switch does not Function  


PROCEDURE

1.CHECK MULTI-DISPLAY
a.

Check if there is any foreign matter caught between the display and exterior frame of the multi-display.

OK:

No foreign matter is caught between the display and exterior frame of the multi-display.


HINT:
·

If there is foreign matter between the display and exterior frame of the multi-display, the touch panel will remain pressed, preventing touch switch operation.

·

Turn the ignition switch to ACC or ON with your hand touching the operating section, non-response may occur.




Result:
Proceed to
OK
NG



OK

2.CHECK TOUCH PANEL

NG

REMOVE FOREIGN MATTER

2.CHECK TOUCH PANEL
a.

Check for foreign matter on the display.

OK:

The display is clean.



Result:
Proceed to
OK
NG



OK

3.CHECK TOUCH SWITCH (OPERATION CHECK)

NG

CLEAN DISPLAY AND RECHECK TOUCH PANEL

3.CHECK TOUCH SWITCH (OPERATION CHECK)
a.
E176521

Enter the "Touch Switch Check" screen. Refer to Check Touch Switch in Operation Check.

Click hereAudio / Visual / Telematics>AUDIO / VIDEO>AUDIO AND VISUAL SYSTEM>OPERATION CHECK


b.

Touch the display in the area where the switch malfunction occurs.

OK:

A "+" mark appears at the touched position.



Result:
Proceed to
OK
NG



OK

REPLACE RADIO AND DISPLAY RECEIVER ASSEMBLY

NG

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE