The No. 1 stereo jack adapter assembly sends the sound data signal or image data signal from a USB device to the radio and display receiver assembly via this circuit.
Disconnect the D147 radio and display receiver assembly connector.
Disconnect the D149 No. 1 stereo jack adapter assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
|
Click Location & Routing(D147,D149)Location & Routingewd_type=routing;type=c,c;code=D147,D149 Click Connector(D147)Instrument Panel>Instrument Panel Wire>Radio Receiver Assemblyewd_type=component;type=c;code=D147;pinno=2,3,5 Click Connector(D149)Instrument Panel>Instrument Panel Wire>No. 1 Stereo Jack Adapter Assemblyewd_type=component;type=c;code=D149;pinno=2,3,5 |
||
| D147-2 (US1-) - D149-2 (UDO-) | Always | Below 1 Ω |
| D147-3 (US1+) - D149-3 (UDO+) | Always | Below 1 Ω |
| D147-5 (USG1) - D149-5 (UJSS) | Always | Below 1 Ω |
| D147-2 (US1-) - Body ground | Always | 10 kΩ or higher |
| D147-3 (US1+) - Body ground | Always | 10 kΩ or higher |
| D147-5 (USG1) - Body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG