Home › Audio / Visual / Telematics › AUDIO / VIDEO › AUDIO AND VISUAL SYSTEM
RM37H0E _56 Audio / Visual / Telematics _095260 AUDIO / VIDEO _0455059 AUDIO AND VISUAL SYSTEM J

AUDIO / VIDEO  AUDIO AND VISUAL SYSTEM  Reverse Signal Circuit  


DESCRIPTION

The radio and display receiver assembly receives a reverse signal from the No. 2 semiconductor power integration ECU.

WIRING DIAGRAM

E442579E09
4.917,1.99 5.219,2.188 0.302,0.198 10 false D54 4.917,2.146 6.635,2.781 1.719,0.635 10 false Radio and Display Receiver Assembly 5.396,1.083 5.76,1.281 0.365,0.198 10 false REV 5.135,0.99 5.594,1.188 0.458,0.198 10 false 28 0.979,1.042 2.604,1.427 1.625,0.385 10 false from No. 2 Semiconductor Power Integration ECU

PROCEDURE

1.CHECK BACK-UP LIGHT
a.

Move the shift lever to R and check if the back-up lights come on.

OK:

The back-up lights come on.



Result:
Proceed to
OK
NG



OK

2.CHECK HARNESS AND CONNECTOR (REVERSE SIGNAL)

NG

2.CHECK HARNESS AND CONNECTOR (REVERSE SIGNAL)
a.

Disconnect the D54 radio and display receiver assembly connector.


b.

Measure the voltage according to the value(s) in the table below.

Standard Voltage:
Tester Connection Condition Specified Condition

Click Location & Routing(D54)Location & Routing

Click Connector(D54)Instrument Panel>Instrument Panel Wire>Radio Receiver Assembly

D54-28 (REV) - Body ground Ignition switch ON
Shift lever in R
11 to 14 V
D54-28 (REV) - Body ground Ignition switch ON
Shift lever not in R
Below 1 V



Result:
Proceed to
OK
NG



OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR