Home › Brake › PARKING BRAKE › ELECTRIC PARKING BRAKE SYSTEM
RM37H0E _54 Brake _096946 PARKING BRAKE _0455727 ELECTRIC PARKING BRAKE SYSTEM D

PARKING BRAKE  ELECTRIC PARKING BRAKE SYSTEM  UTILITY  


PERFORM EPB INITIAZE AND ACQUIRE TENSION SENSOR ZERO POINT


NOTICE:

If the parking brake ECU assembly or parking brake actuator assembly with bracket is replaced, perform the "EPB Initialize" and "Acquire Tension Sensor Zero Point" procedures.


a.

Using the GTS, perform "EPB Initialize".

Chassis > Brake/EPB > Utility
Tester Display
EPB Initialize
50005 435 5691
HINT:
·

EPB stands for electric parking brake

·

When the reset memory is completed, the parking brake indicator light will blink at 1 second intervals (0.5 seconds on and 0.5 seconds off).




b.

Operate the electric parking brake switch assembly to turn the parking brake light off.

HINT:

This procedure acquires the tension sensor zero point.




PARKING BRAKE BEDDING


CAUTION:
·
C349045C01
0.292,2.958 0.604,3.156 0.313,0.198 10 false *a
*a Condition without performing brake bedding


Do not operate the parking brake without first performing brake bedding of the parking brake shoe and rear disc.

·

Performing bedding creates the basic braking force of the parking brake, so without it the parking brake will not provide sufficient braking performance, which may result in a serious accident.



NOTICE:

If one of the following is performed, perform parking brake bedding.

·

Rear disc is replaced or removed and installed.

·

Parking brake shoe is replaced or removed and installed.

·

Parking brake actuator assembly with bracket is replaced or removed and installed.



a.

Turn the ignition switch to ON.


b.

Cancel the AUTO function (shift-linked function).


c.

Change the shift state to P.


d.

Release the parking brake.


e.

Using the GTS, select "Signal Check".

Chassis > Brake/EPB > Utility
Tester Display
Signal Check
50005 435 5558

f.

Follow the Techstream display and select "Next".


g.

Check that test mode is entered.

HINT:

The parking brake indicator light will blink at 0.25 second intervals (0.125 seconds on and 0.125 seconds off).



h.

Perform parking brake bedding.

i.

Drive the vehicle at 30 km/h (19 mph).


ii.

Push the parking brake switch to the lock side for 5 seconds.

NOTICE:

The braking power is generated from the parking brake while driving the vehicle. This will cause the vehicle speed to decrease. Depress the acceleration pedal to maintain the speed at 30 km/h (19 mph).


HINT:
·

While the switch is pushed, the parking brake indicator light stops blinking at 0.25 second intervals (0.125 seconds on and 0.125 seconds off) and illuminates steadily.

·

During this operation, the tension is automatically adjusted.




iii.

After 5 seconds, check that the parking brake indicator light blinks at 0.25 second intervals (0.125 seconds on and 0.125 seconds off).

HINT:

The brake force decreases.



iv.

Release the electric parking brake switch assembly.


v.

Stop the vehicle.


vi.

Turn the ignition switch off.