Home › Brake › PARKING BRAKE › ELECTRIC PARKING BRAKE SYSTEM
RM37H0E _54 Brake _096946 PARKING BRAKE _0455727 ELECTRIC PARKING BRAKE SYSTEM D

PARKING BRAKE  ELECTRIC PARKING BRAKE SYSTEM  FREEZE FRAME DATA  


FREEZE FRAME DATA


HINT:
·

When a DTC is stored, the freeze frame data stores the current vehicle (sensor) state as.

·

The freeze frame data cannot be cleared or updated until the recorded DTCs are cleared.



a.

Using the GTS, the state of the vehicle (sensors) when the system is operating or when a DTC was stored can be checked.

Chassis > Brake/EPB
Tester Display Measurement Item Range Normal Condition Diagnostic Note
FR Wheel Speed Front wheel speed sensor RH reading Min.: 0.0 km/h (0.0 mph)
Max.: 6553.5 km/h (4072 mph)
Vehicle stopped: 0.0 km/h (0 mph) When driving at constant speed: No large fluctuations
FL Wheel Speed Front wheel speed sensor LH reading Min.: 0.0 km/h (0.0 mph)
Max.: 6553.5 km/h (4072 mph)
Vehicle stopped: 0.0 km/h (0 mph) When driving at constant speed: No large fluctuations
RR Wheel Speed Rear wheel speed sensor RH reading Min.: 0.0 km/h (0.0 mph)
Max.: 6553.5 km/h (4072 mph)
Vehicle stopped: 0.0 km/h (0 mph) When driving at constant speed: No large fluctuations
RL Wheel Speed Rear wheel speed sensor LH reading Min.: 0.0 km/h (0.0 mph)
Max.: 6553.5 km/h (4072 mph)
Vehicle stopped: 0.0 km/h (0 mph) When driving at constant speed: No large fluctuations
Forward and Rearward G Forward and rearward G Min.: -25.105 m/s2
Max.: 24.908 m/s2
During deceleration: -25.105 to 0.000 m/s2
During acceleration: 0.000 to 24.908 m/s2
During acceleration/deceleration: Changes in proportion with acceleration
Accelerator Opening Angle % Percentage of accelerator pedal opening angle Min.: 0.0%
Max.: 127.5%
Accelerator pedal released: 0.0% During accelerator pedal operation: Changes in proportion with the pedal movement
Shift Lever Position Shift lever position information fail / 1st / 2nd / 3rd / 4th / 5th / 6th / B / D/M / N / P / R / No input Actual shift lever position -
Vehicle Speed Vehicle speed
(estimated vehicle speed used for various controls)
Min.: 0.0 km/h (0.0 mph)
Max.: 6553.5 km/h (4072 mph)
Vehicle stopped: 0.0 km/h (0.0 mph) When driving at constant speed: No large fluctuations
Vehicle Speed Grade Vehicle acceleration/deceleration Min.: -25.105 m/s2
Max.: 24.908 m/s2
Vehicle stopped: 0.000 m/s2
During deceleration: -25.105 to 0.000 m/s2
During acceleration: 0.000 to 24.908 m/s2
During driving: Changes in proportion with vehicle acceleration/deceleration
IG Switch Ignition switch ON status OFF / ON - -
Parking Brake SW Parking brake status OFF / ON OFF: Parking brake released
ON: Parking brake applied
-
Deceleration Open Acceleration sensor open detection Normal / Under intermittent Normal: Momentary interruption not detected
Under intermittent: Momentary interruption detected
-
A/C ECU Communication Open Air conditioning amplifier assembly communication open detection Normal / Under intermittent Normal: Momentary interruption not detected
Under intermittent: Momentary interruption detected
-
HV Communication Open EV control ECU communication open detection Normal / Under intermittent Normal: Momentary interruption not detected
Under intermittent: Momentary interruption detected
-
ECU +B1 Voltage No. 2 skid control ECU (brake actuator assembly) +B1 voltage Min.: 0.0 V
Max.: 25.5 V
11.0 to 14.0 V -
EPB Switch Electric parking brake switch assembly input Neutral / Apply / Release / Unknown Neutral: Lock switch and release switch are off
Apply: Lock switch on
Release: Release switch on
When not normal, Electric parking brake switch assembly release side system may be malfunctioning
HINT:

EPB stands for electric parking brake.


Vehicle Speed (Control Value) Vehicle speed (control value) Min.: 0.0 km/h (0 mph)
Max.: 6553.5 km/h (4072 mph)
Vehicle stopped: 0.0 km/h (0.0 mph) When driving at constant speed: No large fluctuations
EPB Warning Light Brake system warning light (yellow indicator) output signal OFF / ON OFF: Brake system warning light (yellow indicator) turns off
ON: Brake system warning light (yellow indicator) illuminates
HINT:

EPB stands for electric parking brake.


Auto Mode Request Auto mode request status Manual mode request / Auto mode request - -
EPB Lock Request Lock demand status Not requested / requested -
HINT:

EPB stands for electric parking brake.


Auto Mode AUTO (shift-linked) mode permission status OFF / ON OFF: Manual mode
ON: AUTO (shift-linked) mode
-
Dynamic PKB Mode Dynamic parking brake operation status OFF / ON OFF: Dynamic parking brake is not operating
ON: Dynamic parking brake is operating
-
RH Actuator Motor Relay1 - - - This item is displayed in the freeze frame data, but it is not used for this vehicle
RH Actuator Motor Relay2 - - - This item is displayed in the freeze frame data, but it is not used for this vehicle
RH Actuator Motor Relay3 - - - This item is displayed in the freeze frame data, but it is not used for this vehicle
RH Actuator Motor Relay4 - - - This item is displayed in the freeze frame data, but it is not used for this vehicle
LH Actuator Motor Relay1 - - - This item is displayed in the freeze frame data, but it is not used for this vehicle
LH Actuator Motor Relay2 - - - This item is displayed in the freeze frame data, but it is not used for this vehicle
LH Actuator Motor Relay3 - - - This item is displayed in the freeze frame data, but it is not used for this vehicle
LH Actuator Motor Relay4 - - - This item is displayed in the freeze frame data, but it is not used for this vehicle
FR Speed Signal Status Front wheel RH speed signal status Normal / Fixed Normal: Wheel speed signal not stuck
Fixed: Wheel speed signal stuck
-
FL Speed Signal Status Front wheel LH speed signal status Normal / Fixed Normal: Wheel speed signal not stuck
Fixed: Wheel speed signal stuck
-
RR Speed Signal Status Rear wheel RH speed signal status Normal / Fixed Normal: Wheel speed signal not stuck
Fixed: Wheel speed signal stuck
-
RL Speed Signal Status Rear wheel LH speed signal status Normal / Fixed Normal: Wheel speed signal not stuck
Fixed: Wheel speed signal stuck
-
RH Actuator Current Status - - - This item is displayed in the freeze frame data, but it is not used for this vehicle
LH Actuator Current Status - - - This item is displayed in the freeze frame data, but it is not used for this vehicle
Permission of Interlocking Shift AUTO (shift-linked) mode permission status Available / Not available - -
Permission of Interlocking Brake Brake-linked permission status Available / Not available - -
Permission of RH Interlocking PKB Lock - - - This item is displayed in the freeze frame data, but it is not used for this vehicle
Permission of RH Interlocking PKB Release - - - This item is displayed in the freeze frame data, but it is not used for this vehicle
Permission of RH Interlocking Dynamic PKB - - - This item is displayed in the freeze frame data, but it is not used for this vehicle
Permission of RH Interlocking PKB Full Release - - - This item is displayed in the freeze frame data, but it is not used for this vehicle
Permission of LH Interlocking PKB Lock - - - This item is displayed in the freeze frame data, but it is not used for this vehicle
Permission of LH Interlocking PKB Release - - - This item is displayed in the freeze frame data, but it is not used for this vehicle
Permission of LH Interlocking Dynamic PKB - - - This item is displayed in the freeze frame data, but it is not used for this vehicle
Permission of LH Interlocking PKB Full Release - - - This item is displayed in the freeze frame data, but it is not used for this vehicle
Fade Status Fade status OFF / ON - -
RH Actuator Motor Current High - - - This item is displayed in the freeze frame data, but it is not used for this vehicle
RH Actuator Motor Driver Operation Status - - - This item is displayed in the freeze frame data, but it is not used for this vehicle
LH Actuator Motor Current High - - - This item is displayed in the freeze frame data, but it is not used for this vehicle
LH Actuator Motor Driver Operation Status - - This item is displayed in the freeze frame data, but it is not used for this vehicle
IG1 Voltage IG1 voltage value Min.: 0.000 V
Max.: 20.000 V
11.000 to 14.000 V -
BS Voltage +BS voltage value Min.: 0.000 V
Max.: 20.000 V
11.000 to 14.000 V -
Tension 1 Voltage Tension sensor 1 value input information is displayed Min.: 0.00 V
Max.: 5.00 V
0.35 to 4.50 V When not normal, tension sensor signal system may be malfunctioning
Tension 2 Voltage Tension sensor 2 value input information is displayed Min.: 0.00 V
Max.: 5.00 V
0.35 to 4.50 V When not normal, tension sensor signal system may be malfunctioning
Zero Point of Tension1 Tension sensor 1 zero point calibration input information is displayed Min.: 0.00 V
Max.: 5.00 V
0.35 to 1.65 V
(after calibrating zero point)
When not normal, tension sensor signal system may be malfunctioning
Zero Point of Tension2 Tension sensor 2 zero point calibration input information is displayed Min.: 0.00 V
Max.: 5.00 V
0.35 to 1.65 V
(after calibrating zero point)
When not normal, tension sensor signal system may be malfunctioning
Target Tension Target tension input information is displayed Min.: 0.0 N
Max.: 3571.4 N
- -
Tension Value Current tension value Min.: 0.0 N
Max.: 3571.4 N
- -
Motor Current Value Motor current zero point calibration completed input information is displayed Min.: -4.8 A
Max.: 48.8 A
-1.6 to 1.6 A: Not during control
-1.6 to 49.1 A: During control
When not normal, motor system may be malfunctioning.
Zero Point of Motor Current Motor current zero point calibration input information is displayed Min.: -6.75 A
Max.: 6.70 A
-1.63 to 1.63 A When not normal, motor system may be malfunctioning.
ACT Control Status Parking brake actuator assembly with bracket condition Park Applied / Hold Applied / Released / Applying / Releasing / Completely Released / Unknown - -
PKB Lock Permit Parking brake actuator assembly with bracket parking brake lock control permission status Available / Not available - -
PKB Release Permit Parking brake actuator assembly with bracket parking brake release control permission status Available / Not available - -
Dynamic Parking Permit Parking brake actuator assembly with bracket dynamic parking control permission status Available / Not available - -
Auto Mode Memory AUTO (shift-linked) mode previous stored value ON / OFF - -
Auto Ready Status AUTO control permission status ON / OFF - -
Zero Point of Tension Sensor Tension sensor zero point calibration completed information is displayed Uncomp / Comp Comp -
Invalid Tension Sensor Output Tension sensor output invalid details are displayed Enable / Disable Enable -
Invalid Tension Sensor PWR Tension sensor power source invalid details are displayed Enable / Disable Enable -
Invalid Tension Sensor Comp Tension sensor comparison invalid details are displayed Enable / Disable Enable -