These DTCs are stored if there is a malfunction in the CAN communication system connected to the clearance warning ECU assembly.
If CAN communication system DTCs are stored, they may also be stored in other systems.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | DTC Output from | Priority |
|---|---|---|---|---|---|
| U012687 | Lost Communication with Steering Angle Sensor Module Missing Message | The clearance warning ECU assembly is unable to receive data from the steering sensor for 5.04 seconds or more | CAN communication system | Clearance Warning | B |
| U012987 | Lost Communication with Brake System Control Module Missing Message | The clearance warning ECU assembly is unable to receive data from the skid control ECU for 5 seconds or more | CAN communication system | Clearance Warning | B |
| U014087 | Lost Communication with Body Control Module Missing Message | The clearance warning ECU assembly is unable to receive data from the main body ECU (multiplex network body ECU) for 5 seconds or more | CAN communication system | Clearance Warning | B |
| U015587 | Lost Communication with Instrument Panel Cluster (IPC) Control Module Missing Message | The clearance warning ECU assembly is unable to receive data from the combination meter assembly for 5 seconds or more | CAN communication system | Clearance Warning | B |
| U029387 | Lost Communication with Hybrid/EV Powertrain Control Module Missing | The clearance warning ECU assembly is unable to receive data from the EV control ECU for 5.12 seconds or more | CAN communication system | Clearance Warning | B |
Clear the DTCs.
| Proceed to |
|---|
| NEXT |
NEXT
Check for DTCs.
After turning the ignition from off to ON, wait 10 seconds or more before checking for DTCs.
If CAN communication system DTCs are stored, they may also be stored in other systems.
If the CAN communication system has been inspected and repaired in other systems, the DTCs will not be output when rechecking for DTCs.
If these DTCs are output frequently, duplicate the conditions that caused the problem symptoms and perform the inspection again, even though DTCs were not output when rechecking for DTCs.
| Result | Proceed to |
|---|---|
| DTCs are not output | A |
| DTCs are output | B |
A
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING
B
Click herePower Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM>HOW TO PROCEED WITH TROUBLESHOOTING