Home › Engine / Hybrid System › FC CONTROL › HYDROGEN RECIRCULATION SEPARATOR
RM37H0E _51 Engine / Hybrid System _095966 FC CONTROL _0466406 HYDROGEN RECIRCULATION SEPARATOR G

FC CONTROL  HYDROGEN RECIRCULATION SEPARATOR  INSPECTION  


PROCEDURE

Hide 23C70 1.INSPECT HYDROGEN RECIRCULATION SEPARATOR ASSEMBLY

a.

Measure the resistance.

i.
A480969C01
1.542,0.104 1.865,0.302 0.323,0.198 0.156,0.104 0.469,0.302 0.313,0.198 10 false *a 1.594,0.125 1.906,0.323 0.313,0.198 10 false B26
*a Component without harness connected
(Hydrogen Recirculation Separator Assembly)


Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition

Click Location & Routing(B26)Location & Routing

Click Connector(B26)Engine Compartment>No. 2 Stack Wire>Hydrogen Recirculation Separator Assembly

B26-1 - B26-2 15 to 25°C 10.5 to 12.5 Ω


If the result is not as specified, replace the hydrogen recirculation separator assembly.