Home › Engine / Hybrid System › FC CONTROL › WATER TEMPERATURE SENSOR
RM37H0E _51 Engine / Hybrid System _095966 FC CONTROL _0466408 WATER TEMPERATURE SENSOR G

FC CONTROL  WATER TEMPERATURE SENSOR  INSPECTION  


PROCEDURE

Hide 89422A 1.INSPECT WATER TEMPERATURE SENSOR (for Radiator Side)

CAUTION:
A342307

·

Do not put your hands into the water that has been heated for the inspection.

·

Touching the heated water could result in burns.



a.

Check the resistance.

i.
A354710C13
1.708,0.073 2.083,0.302 0.375,0.229 0.052,0.063 0.302,0.313 0.25,0.25 10 false *a 1.771,0.094 2.094,0.292 0.323,0.198 10 false A50
*a Component without harness connected
(Water Temperature Sensor)


Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition

Click Location & Routing(A50)Location & Routing

Click Connector(A50)Engine Compartment>Front Compartment Main Wire / No. 3 Front Compartment Wire / No. 4 Front Compartment Wire>Engine Coolant Temperature Sensor

A50-1 - A50-2 Approximately 20°C (68°F) 2.32 to 2.59 kΩ
A50-1 - A50-2 Approximately 80°C (176°F) 0.310 to 0.326 kΩ


NOTICE:
·

When putting the water temperature sensor into water to perform inspection, make sure water does not enter the terminal portion.

·

After inspection, wipe away any water droplets adhering to the water temperature sensor.



If the result is not as specified, replace the water temperature sensor.



Hide 89422Q 2.INSPECT WATER TEMPERATURE SENSOR (for FC Stack Side)

CAUTION:
A342307

·

Do not put your hands into the water that has been heated for the inspection.

·

Touching the heated water could result in burns.



a.

Check the resistance.

i.
A402373C09
1.49,0.031 1.875,0.26 0.385,0.229 0.083,0.063 0.323,0.333 0.24,0.271 10 false *a 1.552,0.052 2.01,0.25 0.458,0.198 10 false B12
*a Component without harness connected
(Water Temperature Sensor)


Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition

Click Location & Routing(B12)Location & Routing

Click Connector(B12)Engine Compartment>No. 2 Stack Wire>Exit Cooling water Temperature Sensor (Engine Coolant Temperature Sensor)

B12-1 - B12-2 Approximately 20°C (68°F) 2.32 to 2.59 kΩ
B12-1 - B12-2 Approximately 80°C (176°F) 0.310 to 0.326 kΩ


NOTICE:
·

When putting the water temperature sensor into water to perform inspection, make sure water does not enter the terminal portion.

·

After inspection, wipe away any water droplets adhering to the water temperature sensor.



If the result is not as specified, replace the water temperature sensor.