Home › Engine / Hybrid System › FC CONTROL › PRESSURE SENSOR
RM37H0E _51 Engine / Hybrid System _095966 FC CONTROL _0466409 PRESSURE SENSOR G

FC CONTROL  PRESSURE SENSOR  INSPECTION  


PROCEDURE

Hide 89421S 1.INSPECT VACUUM SENSOR ASSEMBLY

a.
A327353C13
1.375,0.042 1.75,0.271 0.375,0.229 1.292,0.854 1.292,0.354 1.292,0.354 1.125,0.354 true 1.875,0.833 1.875,0.333 1.875,0.333 2.052,0.333 true 0.104,0.094 0.323,0.344 0.219,0.25 10 false *a 0.813,0.281 1.146,0.469 0.333,0.188 10 false THA 2.104,0.26 2.417,0.417 0.313,0.156 10 false E2 1.438,0.073 1.75,0.281 0.313,0.208 10 false B13
*a Component without harness connected
(Vacuum Sensor Assembly)


Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition

Click Location & Routing(B13)Location & Routing

Click Connector(B13)Engine Compartment>No. 2 Stack Wire>Vacuum Sensor Assembly

B13-4 (THA) - B13-2 (E2) 20°C (68°F) 2.09 to 2.81 kΩ


If the result is not as specified, replace the vacuum sensor assembly.