Home › Engine / Hybrid System › FC CONTROL › HYDROGEN PRESSURE SENSOR
RM37H0E _51 Engine / Hybrid System _095966 FC CONTROL _0466410 HYDROGEN PRESSURE SENSOR G

FC CONTROL  HYDROGEN PRESSURE SENSOR  ON-VEHICLE INSPECTION  


PROCEDURE

Hide G4133 1.INSPECT HYDROGEN SECONDARY PRESSURE SENSOR

a.

Check the power source voltage.

i.

Disconnect the hydrogen secondary pressure sensor connector.


ii.

Turn the ignition switch on (IG).


iii.

Measure the voltage according to the value(s) in the table below.

Standard Voltage:
Tester Connection Condition Specified Condition

Click Location & Routing(B11)Location & Routing

Click Connector(B11)Engine Compartment>No. 2 Stack Wire>Hydrogen Secondary Pressure Sensor

B11-3(VHPL) - B11-2(GHPL) IG ON 4.75 to 5.25 V
B11-1(HPL) - B11-2(GHPL) IG ON 3.0 to 5.25 V


HINT:

If the measurement result is approximately 0 V, there may be an open on the VHPL circuit or GHPL circuit.




b.

Check the low-range hydrogen pressure.

i.

Connect the GTS to the DLC3.


ii.

Turn the ignition switch on (IG).


iii.

Enter the following menus: Powertrain / FC / Data List / Low-Range Hydrogen Pressure

Powertrain > FC > Data List
Tester Display
Low-Range Hydrogen Pressure
50003 490 61

iv.

Read the hydrogen secondary pressure sensor value.

OK:

"Atmospheric pressure plus 10 kPa" to "280 kPa(abs)"


HINT:
·

Standard atmospheric pressure is 101 kPa (abs) [758 mmHg (abs)].

·

For every 100 m (328 ft.) increase in altitude, pressure drops by 1 kPa (7.5 mmHg).

·

Make sure that the vehicle is stopped with the ignition switch ON (READY) ("FC Mode" on the Data List (EV) indicates "FC Working" and "FC Intermittent Operation" indicates "OFF").