Home › Engine / Hybrid System › FC CONTROL › HYDROGEN PRESSURE SENSOR
RM37H0E _51 Engine / Hybrid System _095966 FC CONTROL _0466410 HYDROGEN PRESSURE SENSOR G

FC CONTROL  HYDROGEN PRESSURE SENSOR  INSPECTION  


PROCEDURE

Hide G4132 1.INSPECT HYDROGEN PRIMARY PRESSURE SENSOR

a.

Check the hydrogen primary pressure sensor output voltage.

i.
A475866C01
1.771,0.573 1.469,0.25 1.469,0.25 1.302,0.25 true 2.24,0.563 2.521,0.24 2.521,0.24 2.688,0.24 true 0.135,0.135 0.448,0.292 0.313,0.156 10 false *a 1.656,1.833 1.969,1.99 0.313,0.156 10 false *b 0.875,0.177 1.281,0.406 0.406,0.229 10 false VHPM 2.75,0.167 3.156,0.438 0.406,0.271 10 false GHPM
*a Component without harness connected
(Hydrogen Primary Pressure Sensor)
*b Voltage Applied between Terminals


Apply 5 V between terminals 1 (GHPM) and 3 (VHPM).

NOTICE:
·

Be careful when connecting the leads, as the hydrogen primary pressure sensor may be damaged if the leads are connected to the wrong terminals.

·

Do not apply more than 6 V to terminals 1 (GHPM) and 3 (VHPM).



HINT:

If a stable power supply is not available, connect 4 nickel-metal hydride batteries (1.2 V each) or equivalent in series.



ii.
A475867C01
1.552,0.281 1.865,0.469 0.313,0.188 1.521,1.146 1.219,1.656 1.219,1.656 1.219,1.823 true 1.719,1.167 1.979,1.667 1.979,1.667 1.979,1.833 true 0.125,0.125 0.438,0.281 0.313,0.156 10 false *a 1.063,1.865 1.469,2.125 0.406,0.26 10 false VHPM 1.885,1.865 2.198,2.063 0.313,0.198 10 false HPM 1.604,0.302 1.917,0.49 0.313,0.188 10 false B10
*a Component without harness connected
(Hydrogen Primary Pressure Sensor)


Measure the voltage between terminals.

Standard Voltage:
Tester Connection Condition Specified Condition

Click Location & Routing(B10)Location & Routing

Click Connector(B10)Engine Compartment>No. 2 Stack Wire>Hydrogen Primary Pressure Sensor

B10-2 (HPM) - B10-3 (VHPM) Pressure not applied to hydrogen primary pressure sensor Approximately 0.56 to 0.94 V*


*: The output voltage changes depending on the voltage applied to the terminals.

If the result is not as specified, replace the fuel delivery pipe sub-assembly (hydrogen primary pressure sensor).