Home › Engine / Hybrid System › FC CONTROL › FC WATER RELEASE SWITCH
RM37H0E _51 Engine / Hybrid System _095966 FC CONTROL _0466411 FC WATER RELEASE SWITCH G

FC CONTROL  FC WATER RELEASE SWITCH  INSPECTION  


PROCEDURE

Hide 84973 1.INSPECT FC WATER RELEASE SWITCH

a.

Check the resistance.

i.
A475856C01
1.5,0.344 1.906,0.542 0.406,0.198 0.896,1.667 1.313,1.25 true 1.531,1.771 1.615,1.271 true 1.979,1.771 1.844,1.271 true 2.594,1.688 2.135,1.25 true 0.115,0.073 0.396,0.281 0.281,0.208 10 false *a 0.74,1.719 1.125,1.958 0.385,0.24 10 false ILL+ 1.438,1.823 1.823,2.063 0.385,0.24 10 false SW 1.99,1.823 2.375,2.063 0.385,0.24 10 false E 2.563,1.729 2.948,1.969 0.385,0.24 10 false ILL- 1.563,0.365 1.969,0.573 0.406,0.208 10 false D107
*a Component without harness connected
(FC Water Release Switch)


Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition

Click Location & Routing(D107)Location & Routing

Click Connector(D107)Instrument Panel>Instrument Panel Wire>FC Water Release Switch

D107-4 (E) - D107-5 (SW) Switch on Below 1 Ω
D107-4 (E) - D107-5 (SW) Switch off 10 kΩ or higher


If the result is not as specified, replace the FC water release switch.



b.

Check illumination.

i.

Connect the negative auxiliary battery cable and positive auxiliary battery cable to the indicated terminals of the connector and check that the LED illuminates.

OK:
Tester Connection Specified Condition

Click Location & Routing(D107)Location & Routing

Click Connector(D107)Instrument Panel>Instrument Panel Wire>FC Water Release Switch

Auxiliary battery positive (+) → D107-6 (ILL+)
Auxiliary battery negative (-) → D107-3 (ILL-)
LED illuminates


If the result is not as specified, replace the FC water release switch.