Home › Vehicle Exterior › LIGHTING (EXT) › HEIGHT CONTROL SENSOR
RM37H0E _59 Vehicle Exterior _093353 LIGHTING (EXT) _0466507 HEIGHT CONTROL SENSOR G

LIGHTING (EXT)  HEIGHT CONTROL SENSOR  INSPECTION  


PROCEDURE

Hide 89408C 1.INSPECT REAR HEIGHT CONTROL SENSOR SUB-ASSEMBLY LH

a.

Check voltage.

i.

Connect 3 dry cell batteries (1.5 V) in series.

NOTICE:

As a voltage of 1.5 V may not be output, do not use a rechargeable dry cell battery.



ii.

Connect the positive (+) end of the dry cell battery to 3 (SHB) and the negative (-) end to 1 (SHG), and apply a voltage of 4.5 V.

NOTICE:

Do not apply a voltage of 6 V or higher between the terminals.


E457825C01
5.302,2.063 5.729,1.25 true 4.76,3.031 5.125,2.167 true 4.917,2.083 4.719,1.5 true 3.958,0.594 4.271,0.75 0.313,0.156 10 false *a 1.938,0.198 2.25,0.354 0.313,0.156 10 false *d 1.156,2.406 1.615,2.615 0.458,0.208 10 true *e 0.844,1.052 1.156,1.208 0.313,0.156 10 false *c 0.719,1.75 1.031,1.906 0.313,0.156 10 false *b 1.396,3.552 1.708,3.708 0.313,0.156 10 false *f 4.615,3.083 5.073,3.281 0.458,0.198 10 false SHRL 5.781,1.135 6.24,1.333 0.458,0.198 10 false SHG 4.448,1.406 4.906,1.604 0.458,0.198 10 false SHB
*a Component without harness connected
(Rear Height Control Sensor LH)
*b Horizontal Position
*c Sensor Standard Position
(17.8 to 19.0° from the horizontal position)
*d Vehicle Height: Low (full bound) (26.8° from the sensor standard position)
(26.8° from the sensor standard position)
*e High (full rebound)
(28.2° from the sensor standard position)
*f Rebound Side Link Stop Position
(58.0° from the sensor standard position)



iii.

Measure the voltage between the terminals when slowly moving the sensor's link up and down from the sensor standard position while applying voltage.

Standard Voltage:
Tester Connection Condition Specified Condition
1(SHG) - 2(SHRL) Raise the link to the bound side from the sensor standard position (Vehicle height: Low) Full Bound Position Approx. 1.3 V
Sensor Standard Position - Approx. 2.5 V
Lower the link to the rebound side from the sensor standard position (Vehicle height: High) Horizontal Position Approx. 3.3 V
Full Rebound Position Approx. 3.8 V
From 45° down to the link stop position at the rebound side Approx. 4.5 V


HINT:

If the result is not as specified, replace the rear height control sensor sub-assembly LH.