Home › Engine / Hybrid System › HYBRID / BATTERY CONTROL › HYBRID CONTROL SYSTEM
RM37H0E _51 Engine / Hybrid System _096346 HYBRID / BATTERY CONTROL _0463852 HYBRID CONTROL SYSTEM D

HYBRID / BATTERY CONTROL  HYBRID CONTROL SYSTEM  DIAGNOSIS SYSTEM  


DESCRIPTION


The EV control ECU has a self-diagnosis system. If the computer, hybrid control system, or a component is not working properly, the ECU records the conditions that relate to the fault. The ECU also illuminates the master warning in the combination meter assembly and provides other appropriate messages on the multi-information display, such as the EV system warning message, EV supply battery warning message, or discharge warning message.


2 TRIP DETECTION LOGIC


Following is the description for storage of DTC using "2 trip detection logic".

When a malfunction is first detected, the malfunction is temporarily stored in the EV control ECU memory (1st trip). If the same malfunction is detected during the next drive cycle, the MIL is illuminated (2nd trip).



FREEZE FRAME DATA


The EV control ECU records vehicle and driving condition information as freeze frame data the moment a DTC is stored. When troubleshooting, freeze frame data can be helpful in determining whether the vehicle was moving or stationary, whether the hybrid control system was warmed up or not, as well as other data recorded at the time of a malfunction.


AUXILIARY BATTERY VOLTAGE


Standard Voltage:
Switch Condition Specified Condition
Ignition switch ON 11 to 14 V


If voltage is below 11 V, recharge or replace the auxiliary battery.

NOTICE:
·

After turning the ignition switch off, there may be a waiting time before disconnecting the auxiliary negative (-) battery terminal.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION

·

When disconnecting and reconnecting the auxiliary battery.

Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>WORK PROCEDURE

HINT:

When disconnecting and reconnecting the auxiliary battery, there is an automatic learning function that completes learning when the respective system is used.

Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>AUTOMATIC LEARNING CHART






RELEVANT SYSTEMS CHECK


The inspection areas and outline of the inspection for each circuit are listed below.

A338662E02
0.802,0.646 2.354,1.146 1.552,0.5 10 false Water with Motor Pump Assembly (Coolant Path) 1.458,1.708 2.448,2.042 0.99,0.333 10 true Cooling System 1.844,2.073 2.948,2.438 1.104,0.365 10 false Shut Down Signal Circuit 1.271,4.083 2.896,4.396 1.625,0.313 10 false EV Control ECU 1.333,5.615 2.927,5.833 1.594,0.219 10 false Communication Circuit 0.229,2.688 0.875,3.25 0.646,0.563 10 false FC Stack Assembly 1.323,6.521 2.552,6.875 1.229,0.354 10 true Inverter Low-voltage Circuit 5.125,6.167 6.417,6.438 1.292,0.271 10 false EV Supply Battery 4.521,6.667 6.719,6.938 2.198,0.271 10 true EV Battery High-voltage Line Circuit 1.281,7.635 2.698,7.875 1.417,0.24 10 false : Coolant 1.271,8.052 2.688,8.292 1.417,0.24 10 false : High Voltage Line 3.99,7.771 5.406,8.01 1.417,0.24 10 false : Inspection Areas 4.354,5.427 6.76,5.615 2.406,0.188 10 true FC Air Compressor High-voltage Circuit 5.052,4.875 6.271,5.177 1.219,0.302 10 false FC Air Compressor 5.333,3.479 6.167,3.781 0.833,0.302 10 false Drive Motor 4.76,4.031 6.375,4.313 1.615,0.281 10 true Motor High-voltage Circuit 4.833,1.927 6.479,2.302 1.646,0.375 10 false FC Air Compressor Motor Resolver 4.458,2.646 6.688,2.979 2.229,0.333 10 true FC Air Compressor Resolver Circuit 5.063,0.688 6.49,1 1.427,0.313 10 false Drive Motor Resolver 4.823,1.167 6.26,1.448 1.438,0.281 10 true Motor Resolver Circuit 2.74,7.01 4.875,7.271 2.135,0.26 10 false Inverter with Converter Assembly 1.688,4.75 2.802,5.01 1.115,0.26 10 false Shutdown Signal 1.865,2.688 2.719,3.083 0.854,0.396 10 false FC Converter Assembly 0.729,6.24 2.188,6.427 1.458,0.188 10 false Power Source Circuit 1.719,3.25 2.833,3.51 1.115,0.26 10 false Shutdown Signal

Inspection Details of Relevant Systems
System to be Inspected Malfunction Possibility Inspection Content
Cooling System Temperature abnormally high
·

Grille blockage

·

Whether coolant is present

·

Whether there is a possibility that coolant was frozen when malfunction occurs

·

Cooling hose blockage

·

Radiator fan operation


Shutdown Signal System Shutdown signal
·

Open or short circuit in shutdown signal communication line between EV control ECU and motor generator control ECU

·

Short in shutdown signal communication line between FC boost control ECU and EV control ECU


Inverter Low-voltage Circuit Power supply voltage from +B or communication between EV control ECU and motor generator control ECU
·

Open or short circuit in communication line between EV control ECU and motor generator control ECU

·

Open or short circuit in the +B or ground lines

·

Fuse is blown


HV Battery High-voltage Line Circuit High voltage power supply from EV supply battery

Open or short circuit in the system main relay, connectors or cables


Motor Resolver Circuit Drive motor resolver signal

Open or short circuit in the drive motor resolver, connectors or cables


FC Air Compressor Resolver Circuit FC air compressor motor resolver signal

Open or short circuit in the FC air compressor motor resolver, connectors or cables


Motor High-voltage Circuit Drive motor output

Open or short circuit in the drive motor, connectors or cables


FC Air Compressor High-voltage Circuit FC air compressor output

Open or short circuit in the FC air compressor assembly, connectors or cables