Home › Engine / Hybrid System › FC CONTROL › FC CONTROL SYSTEM
RM37H0E _51 Engine / Hybrid System _095966 FC CONTROL _0466766 FC CONTROL SYSTEM C

FC CONTROL  FC CONTROL SYSTEM  P1EF581  Invalid Data Received from Water Heating Heater Invalid Serial Data Received  


DESCRIPTION

If there is a malfunction in the air conditioning amplifier assembly, DTC P1EF581 will be stored.

DTC No. Detection Item DTC Detection Condition Trouble Area Warning Indicate DTC Output from Priority
P1EF581 Invalid Data Received from Water Heating Heater Invalid Serial Data Received Air conditioning amplifier assembly malfunction:
The EV control ECU receives a communication error signal from the air conditioning amplifier assembly.
(1 trip detection logic)
Air conditioning amplifier assembly Master Warning:
Does not come on
EV B

CAUTION / NOTICE / HINT

NOTICE:
·

This vehicle performs FC system shutdown process after turning the ignition switch off from ON (READY). Therefore, after the ignition switch is turned off from ON (READY), do not perform any work on the electrical system for at least 10 minutes including removing connectors or disconnecting the negative (-) auxiliary battery terminal.

·

When the EV control ECU determines that the temperature of FC system components is below 0°C (32°F) when the vehicle is parked with the ignition switch off, it operates the FC air compressor, hydrogen pump and FC cooling water pump for a maximum of 180 seconds to drain the FC stack assembly. When performing inspection or repairs with the ignition switch off (not ON or ON (READY)), disconnect the cable from the negative (-) auxiliary battery terminal before performing work. (If the auxiliary battery voltage is needed to conduct inspection, perform the inspection in an environment with an ambient temperature of 10°C (50°F) or higher.)



HINT:

After the repair, clear the DTCs and perform the following procedure to check that DTCs are not output.

1.

Wait for 1 minute or more with the vehicle stopped, the ignition switch ON (READY), the shift state in park (P), and the air conditioning system on (Lo/COOL MAX, blower speed HI).



PROCEDURE

1.CHECK DTC OUTPUT (AIR CONDITIONER)

Pre-procedure1

a.

None


Procedure1

a.

Check if DTCs related to the air conditioning system (A/C) are output.

Body Electrical > Air Conditioner > Trouble Codes
50001 121
Result:
Result Proceed to
DTCs are not output A
DTCs are output B



Post-procedure1

a.

Turn the ignition switch off.



A

REPLACE AIR CONDITIONING AMPLIFIER ASSEMBLY

B