Home › Engine / Hybrid System › FC CONTROL › FC CONTROL SYSTEM
RM37H0E _51 Engine / Hybrid System _095966 FC CONTROL _0466766 FC CONTROL SYSTEM C

FC CONTROL  FC CONTROL SYSTEM  P060B16  Internal Control Module A/D Processing Performance Circuit Voltage Below Threshold  P060B1C  Internal Control Module A/D Processing Performance Circuit Voltage Out of Range  P060B49  Internal Control Module A/D Processing Performance Internal Electronic Failure  P060B71  Internal Control Module A/D Processing Performance Actuator Stuck  


DESCRIPTION

The FC boost control ECU monitors its internal operation and will store these DTCs when it detects an internal malfunction.

DTC No. Detection Item DTC Detection Condition Trouble Area Warning Indicate DTC Output from Priority
P060B16 Internal Control Module A/D Processing Performance Circuit Voltage Below Threshold AD conversion was not completed after 1 second or more has elapsed after starting the conversion process.
(1 trip detection logic)
FC boost control ECU Master Warning: Comes on FCDC A
P060B1C Internal Control Module A/D Processing Performance Circuit Voltage Out of Range When the +B voltage is not low with the ignition switch ON, an ECU internal error occurs. (Abnormal AD conversion)
(1 trip detection logic)
FC boost control ECU Master Warning: Comes on FCDC A
P060B49 Internal Control Module A/D Processing Performance Internal Electronic Failure When the +B voltage is not low with the ignition switch ON, an ECU internal error occurs. (Timeout)
(1 trip detection logic)
FC boost control ECU Master Warning: Comes on FCDC A
P060B71 Internal Control Module A/D Processing Performance Actuator Stuck When the +B voltage is not low with the ignition switch ON, an ECU internal error occurs. (Abnormal multiplexer)
(1 trip detection logic)
FC boost control ECU Master Warning: Comes on FCDC A

CAUTION / NOTICE / HINT

NOTICE:
·

This vehicle performs FC system shutdown process after turning the ignition switch off from ON (READY). Therefore, after the ignition switch is turned off from ON (READY), do not perform any work on the electrical system for at least 10 minutes including removing connectors or disconnecting the negative (-) auxiliary battery terminal.

·

When the EV control ECU determines that the temperature of FC system components is below 0°C (32°F) when the vehicle is parked with the ignition switch off, it operates the FC air compressor, hydrogen pump and FC cooling water pump for a maximum of 180 seconds to drain the FC stack assembly. When performing inspection or repairs with the ignition switch off (not ON or ON (READY)), disconnect the cable from the negative (-) auxiliary battery terminal before performing work. (If the auxiliary battery voltage is needed to conduct inspection, perform the inspection in an environment with an ambient temperature of 10°C (50°F) or higher.)



HINT:

After the repair, clear the DTCs and perform the following procedure to check that DTCs are not output.

1.

Turn the ignition switch off and wait for 10 minutes or more.

2.

Turn the ignition switch to ON and wait for 15 seconds or more.



PROCEDURE

1.REPLACE FC CONVERTER AND FC STACK ASSEMBLY COMPONENT PARTS

Replace the FC converter and FC stack assembly components listed below.

HINT:

Click hereEngine / Hybrid System>FC CONTROL>CONVERTER ASSEMBLY>REMOVAL


·

FC boost control ECU


HINT:
·

Refer to the parts location for the FC converter and FC stack assembly components.

Click hereEngine / Hybrid System>FC CONTROL>FC CONTROL SYSTEM>PARTS LOCATION

·

Refer to the system description for the parts location of the FC converter and FC stack assembly components.

Click hereEngine / Hybrid System>FC CONTROL>FC CONTROL SYSTEM>SYSTEM DESCRIPTION



Result:
Proceed to
NEXT



NEXT

END