Home › Engine / Hybrid System › FC CONTROL › FC CONTROL SYSTEM
RM37H0E _51 Engine / Hybrid System _095966 FC CONTROL _0466766 FC CONTROL SYSTEM C

FC CONTROL  FC CONTROL SYSTEM  P1D2017  FC Converter Input Voltage Sensor Circuit Voltage Above Threshold  


DESCRIPTION

The FC boost control ECU inside the FC converter assembly uses the voltage sensor built into the FC converter to detect the FC voltage before boosting (FVL). The FC boost control ECU monitors the FC converter input voltage sensor circuit and detects malfunctions.

DTC No. Detection Item DTC Detection Condition Trouble Area Warning Indicate DTC Output from Priority
P1D2017 FC Converter Input Voltage Sensor Circuit Voltage Above Threshold FC stack output voltage AD value remains more than 4.9 V for 0.1 seconds or more.
(1 trip detection logic)
FC converter assembly Master Warning: Comes on FCDC A

Related Data List
DTC No. Data List
P1D2017 FC Voltage

CAUTION / NOTICE / HINT

NOTICE:
·

This vehicle performs FC system shutdown process after turning the ignition switch off from ON (READY). Therefore, after the ignition switch is turned off from ON (READY), do not perform any work on the electrical system for at least 10 minutes including removing connectors or disconnecting the negative (-) auxiliary battery terminal.

·

When the EV control ECU determines that the temperature of FC system components is below 0°C (32°F) when the vehicle is parked with the ignition switch off, it operates the FC air compressor, hydrogen pump and FC cooling water pump for a maximum of 180 seconds to drain the FC stack assembly. When performing inspection or repairs with the ignition switch off (not ON or ON (READY)), disconnect the cable from the negative (-) auxiliary battery terminal before performing work. (If the auxiliary battery voltage is needed to conduct inspection, perform the inspection in an environment with an ambient temperature of 10°C (50°F) or higher.)



HINT:

After the repair, clear the DTCs and perform the following procedure to check that DTCs are not output.

Turn the ignition switch to ON and wait for 5 seconds or more.



PROCEDURE

1.REPLACE FC CONVERTER ASSEMBLY
HINT:
·

The FC converter input voltage (FVL) sensor is connected to the FC boost control ECU inside the FC converter assembly. If DTC P1D2017 is output, replace the FC converter assembly.



Result:
Proceed to
NEXT



NEXT

END