Home › General › SPECIFICATIONS › WIPER / WASHER
RM37H0E _V1 General _095078 SPECIFICATIONS _0467087 WIPER / WASHER F

SPECIFICATIONS  WIPER / WASHER  SERVICE DATA  


Front Wiper Switch (for RH Side)
Connector Condition Tester Connection Condition Specified Condition
Component without harness connected z4-14 (MIST) - z4-5 (E) MIST position Below 1 Ω
Except MIST position 10 kΩ or higher
z4-10 (W-OFF) - z4-5 (E) OFF position Below 1 Ω
Except OFF position 10 kΩ or higher
z4-13 (+S) - z4-5 (E) AUTO position*1 Below 1 Ω
INT position*2
Except AUTO position*1 10 kΩ or higher
Except INT position*2
z4-11 (+1) - z4-5 (E) LO position Below 1 Ω
Except LO position 10 kΩ or higher
z4-12 (+2) - z4-5 (E) HI position Below 1 Ω
Except HI position 10 kΩ or higher

Front Wiper Switch (for LH Side)
Connector Condition Tester Connection Condition Specified Condition
Component without harness connected z4-11 (MIST) - z4-4 (E) MIST position Below 1 Ω
Except MIST position 10 kΩ or higher
z4-15 (W-OFF) - z4-4 (E) OFF position Below 1 Ω
Except OFF position 10 kΩ or higher
z4-12 (+S) - z4-4 (E) AUTO position*1 Below 1 Ω
INT position*2
Except AUTO position*1 10 kΩ or higher
Except INT position*2
z4-14 (+1) - z4-4 (E) LO position Below 1 Ω
Except LO position 10 kΩ or higher
z4-13 (+2) - z4-4 (E) HI position Below 1 Ω
Except HI position 10 kΩ or higher

Front Washer Switch (for RH Side)
Connector Condition Tester Connection Condition Specified Condition
Component without harness connected z4-15 (WF) - z4-5 (E) ON Below 1 Ω
OFF 10 kΩ or higher

Front Washer Switch (for LH Side)
Connector Condition Tester Connection Condition Specified Condition
Component without harness connected z4-10 (WF) - z4-4 (E) ON Below 1 Ω
OFF 10 kΩ or higher

Auto Sensitivity Adjustment Switch*1 (for RH Side)
Connector Condition Tester Connection Condition (Switch) Specified Condition
Component without harness connected z4-4 (VR) - z4-5 (E) P1 1102 to 1218 Ω
P2 570 to 630 Ω
P3 256.5 to 283.5 Ω
P4 Below 1 Ω

Auto Sensitivity Adjustment Switch*1 (for LH Side)
Connector Condition Tester Connection Condition (Switch) Specified Condition
Component without harness connected z4-5 (VR) - z4-4 (E) P1 1102 to 1218 Ω
P2 570 to 630 Ω
P3 256.5 to 283.5 Ω
P4 Below 1 Ω

Intermittent Time Adjustment Switch*2 (for RH Side)
Connector Condition Tester Connection Condition (Switch) Specified Condition
Component without harness connected z4-4 (VR) - z4-5 (E) P1 1102 to 1218 Ω
P2 570 to 630 Ω
P3 256.5 to 283.5 Ω
P4 Below 1 Ω

Intermittent Time Adjustment Switch*2 (for LH Side)
Connector Condition Tester Connection Condition (Switch) Specified Condition
Component without harness connected z4-5 (VR) - z4-4 (E) P1 1102 to 1218 Ω
P2 570 to 630 Ω
P3 256.5 to 283.5 Ω
P4 Below 1 Ω

Camera Washer Switch (for RH Side)
Connector Condition Tester Connection Condition Specified Condition
Component without harness connected z4-9 (WR) - z4-5 (E) ON Below 1 Ω
OFF 10 kΩ or higher

Camera Washer Switch (for LH Side)
Connector Condition Tester Connection Condition Specified Condition
Component without harness connected z4-16 (WR) - z4-4 (E) ON Below 1 Ω
OFF 10 kΩ or higher

*1: w/ Auto Wiper System

*2: w/o Auto Wiper System