Home › Suspension › TIRE PRESSURE MONITORING › TIRE PRESSURE WARNING SYSTEM › from 2021.08
RM37H0E _53 Suspension _096766 TIRE PRESSURE MONITORING _0454878 TIRE PRESSURE WARNING SYSTEM C

TIRE PRESSURE MONITORING  TIRE PRESSURE WARNING SYSTEM  C2128  Auto ID Under Registration  


DESCRIPTION

for ECE-R64 Type and FMVSS138 Type:

When ID registration is being performed via the automatic ID registration function of the tire pressure warning valve and transmitters, the tire pressure warning ECU and receiver outputs C2128 and the tire pressure warning light flashes for 1 minute. Afterward, the tire pressure warning light remains illuminated.

for GB26149 Type:

When ID registration is being performed via the automatic ID registration function of the tire pressure warning valve and transmitters, the tire pressure warning ECU and receiver outputs C2128 and the tire pressure warning light flashes.

When the tire pressure warning valve and transmitters receive the data from all tire pressure warning valve and transmitters with registered IDs, the tire pressure is judged to be normal and the tire pressure warning light turns off.

DTC No. Detection Item DTC Detection Condition Trouble Area DTC Output from Priority
C2128 Auto ID Under Registration While ID registration is performed via the automatic ID registration function of the tire pressure warning valve and transmitter Electronically controlled brake system Tire Pressure Monitor B

PROCEDURE

1.CHECK FOR DTC (ELECTRONICALLY CONTROLLED BRAKE SYSTEM)
a.

Check if the electronically controlled brake system DTC is output.

Chassis > Brake/EPB > Trouble Codes
50001 435
HINT:

If DTC C2128 is output, electronically controlled brake system DTCs may also have been detected. Check the electronically controlled brake system first and after repairs have been completed, perform ID registration via the automatic ID registration function.



Result:
Result Proceed to
Electronically controlled brake system DTC is not output A
Electronically controlled brake system DTC is output B



A

2.REGISTRATION OF TRANSMITTER ID (ID REGISTRATION VIA AUTOMATIC ID REGISTRATION FUNCTION)

B

2.REGISTRATION OF TRANSMITTER ID (ID REGISTRATION VIA AUTOMATIC ID REGISTRATION FUNCTION)

Pre-procedure1

a.

Turn the ignition switch off.


b.

Turn the ignition switch to ON.


Procedure1

a.

Perform ID registration for the tire pressure warning ECU and receiver (ID registration via the automatic ID registration function).

HINT:

Perform the following procedures within 1 trip and do not turn the ignition switch off.



Result:
Proceed to
NEXT


Post-procedure1

a.

None



NEXT

3.READ VALUE USING GTS ([RAM] AUTO ID REGISTERED WHEEL JUDGMENT STATUS)
3.READ VALUE USING GTS ([RAM] AUTO ID REGISTERED WHEEL JUDGMENT STATUS)

Pre-procedure1

a.

According to the display on the GTS, display the ECU Data List.

Chassis > Tire Pressure Monitor > Data List
Tester Display
[RAM] Auto ID Registered FL Wheel Judgment Status
[RAM] Auto ID Registered FR Wheel Judgment Status
[RAM] Auto ID Registered RL Wheel Judgment Status
[RAM] Auto ID Registered RR Wheel Judgment Status
50003 203 88,89,90,91

Procedure1

a.

Refer to the following chart and check the "[RAM] Auto ID Registered Wheel Judgment Status" of each transmitter.

Chassis > Tire Pressure Monitor > Data List
Tester Display Measurement Item Range Normal Condition Diagnostic Note
[RAM] Auto ID Registered FL Wheel Judgment Status FL wheel registration condition (RAM) during automatic ID registration Fixed, Under a Judgment of Side by Side Car Influence or Under a Judgment, Not Registered Actual registration status Cleared each time the ignition switch is turned ON from off.
[RAM] Auto ID Registered FR Wheel Judgment Status FR wheel registration condition (RAM) during automatic ID registration Fixed, Under a Judgment of Side by Side Car Influence or Under a Judgment, Not Registered Actual registration status Cleared each time the ignition switch is turned ON from off.
[RAM] Auto ID Registered RL Wheel Judgment Status RL wheel registration condition (RAM) during automatic ID registration Fixed, Under a Judgment of Side by Side Car Influence or Under a Judgment, Not Registered Actual registration status Cleared each time the ignition switch is turned ON from off.
[RAM] Auto ID Registered RR Wheel Judgment Status RR wheel registration condition (RAM) during automatic ID registration Fixed, Under a Judgment of Side by Side Car Influence or Under a Judgment, Not Registered Actual registration status Cleared each time the ignition switch is turned ON from off.

Result:
Result Proceed to
Displays either "[RAM] Auto ID Registered Wheel Judgment Status" data as " Under a Judgment of Side by Side Car Influence". A
Displays all "[RAM] Auto ID Registered Wheel Judgment Status" data as "Under a Judgment of Side by Side Car Influence". B


Post-procedure1

a.

None



A

4.REGISTRATION OF TRANSMITTER ID (ID REGISTRATION VIA GTS)

B

5.REGISTRATION OF TRANSMITTER ID (ID REGISTRATION VIA GTS)
4.REGISTRATION OF TRANSMITTER ID (ID REGISTRATION VIA GTS)
a.

Perform ID registration for the tire pressure warning ECU and receiver (ID registration via GTS).

Click hereSuspension>TIRE PRESSURE MONITORING>TIRE PRESSURE WARNING SYSTEM>REGISTRATION


Result:
Proceed to
NEXT



NEXT

END

Explain to customers that there is a high possibility that they traveled in parallel to another vehicle with the same type of tire pressure warning valve and transmitter during ID registration via the automatic ID registration function.


5.REGISTRATION OF TRANSMITTER ID (ID REGISTRATION VIA GTS)
a.

Perform ID registration for the tire pressure warning ECU and receiver (ID registration via GTS).

Click hereSuspension>TIRE PRESSURE MONITORING>TIRE PRESSURE WARNING SYSTEM>REGISTRATION


Result:
Proceed to
NEXT



NEXT

END

Explain to customers that it may take time for registration to complete depending on the driving conditions.

Identification may take longer than normal in the following driving environments.

·

Vehicle is often stopped

·

Vehicle is stopped for long period of time

·

Vehicle is driven in reverse

·

Vehicle was not stopped for 15 minutes or more before registration

·

Vehicle was driven at 40 km/h (25 mph) or less for a long duration of time

·

The ignition switch is turned from ON to off during ID registration