Use the following procedure to troubleshoot the occupant classification system.
*: Use the GTS.
| Proceed to |
|---|
| NEXT |
NEXT
Confirm problem symptoms.
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING
| Proceed to |
|---|
| NEXT |
NEXT
Using the GTS, check that the CAN communication system is functioning normally.
CAN communication system is functioning normally.
Refer to CAN Bus Check in CAN Communication System.
Click herePower Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM>DIAGNOSIS SYSTEM
The occupant detection ECU is connected to the CAN communication system. Therefore, before starting troubleshooting, make sure to check that there are no malfunctions in the CAN communication system.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Click herePower Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM>HOW TO PROCEED WITH TROUBLESHOOTING
Refer to Diagnosis System.
Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>OCCUPANT CLASSIFICATION SYSTEM>DIAGNOSIS SYSTEM
| Proceed to |
|---|
| NEXT |
NEXT
Refer to DTC Check / Clear.
DTCs are not output.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Refer to Diagnostic Trouble Code Chart.
| Proceed to |
|---|
| NEXT |
NEXT
| Proceed to |
|---|
| NEXT |
NEXT
| Proceed to |
|---|
| NEXT |
NEXT
Refer to DTC Check / Clear.
| Proceed to |
|---|
| NEXT |
NEXT
Refer to DTC Check / Clear.
DTCs are not output.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Check the passenger airbag ON/OFF indicator condition.
| Proceed to |
|---|
| NEXT |
NEXT
| Proceed to |
|---|
| NEXT |
NEXT