Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › OCCUPANT CLASSIFICATION SYSTEM › from 2021.08
RM37H0E _58 Vehicle Interior _095287 SUPPLEMENTAL RESTRAINT SYSTEMS _0490698 OCCUPANT CLASSIFICATION SYSTEM C

SUPPLEMENTAL RESTRAINT SYSTEMS  OCCUPANT CLASSIFICATION SYSTEM  B1798  Yaw Rate Sensor Module Malfunction  B1799  Vehicle Stability Control ECU Malfunction  


DESCRIPTION

The occupant detection ECU receives signals from the yaw rate sensor and skid control ECU via CAN communication.

DTC No. Detection Item DTC Detection Condition Trouble Area DTC Output from Priority
B1798 Yaw Rate Sensor Module Malfunction Acceleration signals are abnormal
·

Electronically controlled brake system

·

CAN communication system

·

Occupant detection ECU


Occupant Detection B
B1799 Vehicle Stability Control ECU Malfunction Vehicle speed signal from skid control ECU is abnormal
·

Electronically controlled brake system

·

CAN communication system

·

Occupant detection ECU


Occupant Detection B

CAUTION / NOTICE / HINT

HINT:
·

When RoB X2102 is stored as a result of troubleshooting for the airbag system, check the DTCs stored in the occupant detection ECU. When DTC B1798 or B1799 is output, perform troubleshooting for this DTC first.

·

If it is difficult to perform troubleshooting (wire harness inspection), remove the front passenger seat installation bolts to see under the seat cushion.

·

In the above case, lift and hold the seat so that it does not fall down. Hold the seat only as necessary because holding the seat for a long period of time may cause seat rail deformation.



PROCEDURE

1.CHECK DTC (ELECTRONICALLY CONTROLLED BRAKE SYSTEM)
a.

Check for electronically controlled brake system DTCs.

OK:

DTCs are not output.



Result:
Proceed to
OK
NG



OK

2.CHECK CAN COMMUNICATION SYSTEM

NG

2.CHECK CAN COMMUNICATION SYSTEM
a.

Using the GTS, check if the CAN communication system is functioning normally.

OK:

CAN communication system is functioning normally.


HINT:

Refer to CAN Bus Check in CAN Communication System.

Click herePower Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM>DIAGNOSIS SYSTEM



Result:
Proceed to
OK
NG



OK

3.CHECK DTC (HEALTH CHECK)

NG

3.CHECK DTC (HEALTH CHECK)
a.

Perform the Health Check.

OK:

DTCs are not output.



Result:
Proceed to
OK
NG



OK

NG

GO TO OTHER DIAGNOSTIC TROUBLE CODE CHART