DATA LIST
In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.
Using the GTS to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.
Read the Data List according to the display on the GTS.
| Tester Display | Measurement Item | Range | Normal Condition | Diagnostic Note |
|---|---|---|---|---|
| Half Latch SW | Luggage door closer assembly (half latch switch) signal | OFF or ON | ON: Luggage door closer assembly open-latched
OFF: Luggage door closer assembly full-latched or half-latched |
- |
| Pawl Position Switch | Luggage door closer assembly (pawl switch) signal | OFF or ON | ON: Luggage door closer assembly open-latched
OFF: Luggage door closer assembly except open-latched |
- |
| Closer Sensor Battery Voltage | Luggage door closer assembly sensor voltage display | 0 to 25.5 V | 6.4 V or Higher | - |
| IG SW | Ignition switch signal | OFF or ON | OFF: Ignition switch off
ON: Ignition switch ON |
"OFF" is also displayed for this item when the ignition switch is ACC. |
| Closer Power Operation | Function that enables or disables the luggage compartment door closer | OFF or ON | Customized value displayed | - |
| #Codes | Number of trouble codes | 0 to 255 | Number of stored DTCs displayed | - |
| Tester Display | Measurement Item | Range | Normal Condition | Diagnostic Note |
|---|---|---|---|---|
| Tr/B-Door Unlock SW | Luggage electrical key switch | OFF or ON | OFF: Luggage electrical key switch not pushed
ON: Luggage electrical key switch pushed |
·
Displays whether the luggage electrical key switch is on or off. ·
Use this Data List item to help determine if there is a switch malfunction when the entry luggage compartment open function does not operate. |
ACTIVE TEST
Using the GTS, perform the Active Tests allows relays, VSVs and actuators and other items to be operated without removing any parts. This non-intrusive functional inspection can be very useful because intermittent operation may be discovered before parts or wiring is disturbed. Performing Active Tests early in troubleshooting is one way to save diagnostic time. Data List information can be displayed while performing Active Tests.
Perform the Active Test according to the display on the GTS.
| Tester Display | Measurement Item | Control Range | Diagnostic Note |
|---|---|---|---|
| Latch Release | Luggage door closer assembly (latch release) operation | ON or OFF | - |
| Courtesy SW Signal | Luggage door closer assembly (luggage compartment door courtesy switch) signal | OFF or ON | - |