Home › Vehicle Interior › METER / GAUGE / DISPLAY › METER / GAUGE SYSTEM › from 2021.08
RM37H0E _58 Vehicle Interior _095316 METER / GAUGE / DISPLAY _0455143 METER / GAUGE SYSTEM U

METER / GAUGE / DISPLAY  METER / GAUGE SYSTEM  TERMINALS OF ECU  


COMBINATION METER ASSEMBLY


E308357E12
2.188,0.292 2.688,0.531 0.5,0.24 4.906,0.292 5.406,0.531 0.5,0.24 2.313,0.333 2.771,0.531 0.458,0.198 10 false D41 5.031,0.333 5.49,0.531 0.458,0.198 10 false D42

a.

Disconnect the combination meter assembly connectors.


b.

Measure the voltage and resistance according to the value(s) in the table below.

Terminal No. Terminal Description Condition Specified Condition
D41-21 (IG+) - Body ground Ignition switch signal Ignition switch off Below 1 V
Ignition switch ON 11 to 14 V
D41-22 (B) - Body ground Auxiliary battery Ignition switch off 11 to 14 V
D42-1 (B) - Body ground Auxiliary battery Ignition switch off 11 to 14 V
D41-39 (ILL-) - Body ground Illumination signal Headlight dimmer switch off Below 1 V
Headlight dimmer switch in tail or head position 11 to 14 V
D41-38 (IL2-) - Body ground Illumination signal Headlight dimmer switch off Below 1 V
Headlight dimmer switch in tail or head position 11 to 14 V
D41-40 (EP) - Body ground Ground Always Below 1 Ω


c.

Reconnect the combination meter assembly connectors.


d.

Measure the voltage and resistance and check for pulses according to the value(s) in the table below.

Terminal No. (Symbol) Terminal Description Condition Specified Condition

*1: w/o Occupant Classification System

*2: w/o All Auto Control

D41-2 (MSM+) - Body ground Steering pad switch signal Ignition switch ON, enter, trip and back switches on steering pad switch not pushed 4.3 to 5.2 V
Ignition switch ON, enter switch on steering pad switch pushed Below 0.6 V
Ignition switch ON, trip switch on steering pad switch pushed 1.0 to 2.2 V
Ignition switch ON, back switch on steering pad switch pushed 2.3 to 3.4 V
D41-3 (MSTI) - Body ground Steering pad switch signal Ignition switch ON, up, down, right and left switches on steering pad switch assembly not pushed 4.3 to 5.2 V
Ignition switch ON, left switch on steering pad switch pushed Below 0.6 V
Ignition switch ON, up switch on steering pad switch pushed 1.0 to 2.2 V
Ignition switch ON, down switch on steering pad switch pushed 2.3 to 3.4 V
Ignition switch ON, right switch on steering pad switch pushed 3.4 to 4.5 V
D41-4 (ODO) - Body ground ODO/TRIP switch signal Ignition switch ON, ODO/TRIP switch not pushed 4 to 6 V
Ignition switch ON, ODO/TRIP switch pushed Below 1 V
D41-6 (PODS) - Body ground*1 Occupant detection sensor signal Front passenger seat occupied Below 100 Ω
Front passenger seat not occupied 1 MΩ or higher
D41-7 (TX-) Local bus communication line - -
D41-8 (TX+) Local bus communication line - -
D41-12 (RRSB) - Body ground Rear RH seat belt buckle switch signal Ignition switch ON, Rear RH seat belt fastened. 11 to 14 V
Ignition switch ON, Rear RH seat belt unfastened. Below 1 V
D41-13 (RCSB) - Body ground Rear center seat belt buckle switch signal Ignition switch ON, Rear center seat belt fastened. 11 to 14 V
Ignition switch ON, Rear center seat belt unfastened. Below 1 V
D41-14 (RLSB) - Body ground Rear LH seat belt buckle switch signal Ignition switch ON, Rear LH seat belt fastened. 11 to 14 V
Ignition switch ON, Rear LH seat belt unfastened. Below 1 V
D41-18 (PBKL) - Body ground*2 Front passenger seat belt buckle switch signal Front passenger seat belt fastened 10 kΩ or higher
Front passenger seat belt unfastened Below 1 Ω
D41-19 (+S) - Body ground Speed signal for other system Ignition switch ON, wheel being rotated Pulse generation (See waveform 1)
D41-20 (SI) - Body ground Speed signal for other system Ignition switch ON, wheel being rotated Pulse generation (See waveform 1)
D41-25 (TR) - Body ground Light control rheostat switch signal Ignition switch ON, up switch and down switch of trip switch not pushed 4 to 6 V
Ignition switch ON, up switch or down switch of trip switch pushed Below 1 V
D41-26 (SW3) - Body ground Ground for trip switch Always Below 1 Ω
D41-29 (CANH) CAN communication line - -
D41-30 (CANL) CAN communication line - -
D41-31 (ES) - Body ground Ground Always Below 1 Ω
D42-2 (HAZ) - Body ground Hazard warning signal switch signal Hazard warning signal switch off 11 to 14 V
Hazard warning signal switch on Below 1 V
D42-5 (TRNR) - Body ground Rear turn signal light RH signal Ignition switch ON, RH turn indicator light off Below 1 V
Ignition switch ON, RH turn indicator light blinking 11 to 14 V ←→ Below 1 V
D42-6 (INT) - Body ground Tire pressure warning light signal Ignition switch ON, tire pressure warning light off Below 1 V
Ignition switch ON, tire pressure warning light on 11 to 14 V
D42-7 (LR) - Body ground Front/Side turn signal light RH signal Ignition switch ON, RH turn indicator light off Below 1 V
Ignition switch ON, RH turn indicator light blinking 11 to 14 V ←→ Below 1 V
D42-11 (TRNL) - Body ground Rear turn signal light LH signal Ignition switch ON, LH turn indicator light off Below 1 V
Ignition switch ON, LH turn indicator light blinking 11 to 14 V ←→ Below 1 V
D42-13 (LL) - Body ground Front/Side turn signal light LH signal Ignition switch ON, LH turn indicator light off Below 1 V
Ignition switch ON, LH turn indicator light blinking 11 to 14 V ←→ Below 1 V

If the result is not as specified, the combination meter assembly may be malfunctioning.

i.
E219436E10
2.667,1.135 3.01,1.313 0.344,0.177 10 false GND

Waveform 1 (Reference):

Item Condition
Tester Connection
·

D41-20 (SI) - Body ground

·

D41-19 (+S) - Body ground


Tool Setting 5 V/DIV., 20 ms./DIV.
Vehicle Condition Ignition switch ON, wheel being rotated

HINT:

When the system is functioning normally, one wheel revolution generates 4 pulses. As the vehicle speed increases, the width indicated by (A) in the illustration narrows.