PRECAUTION FOR DISCONNECTING CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL
After the ignition switch is turned off, the radio receiver assembly records various types of memory and settings. As a result, after turning the ignition switch off, make sure to wait at least 120 seconds before disconnecting the cable from the negative (-) auxiliary battery terminal.
| System Name | See Procedure |
|---|---|
| Vehicle enrolled in telematics system (for TOYOTA Connect) | 6 minutes |
| Vehicle not enrolled in telematics system (for TOYOTA Connect) | 1 minute |
PRECAUTION FOR NAVIGATION SYSTEM
After performing any of the following procedures, the navigation system may restart after the ignition switch to ACC for first time (due to radio receiver assembly and navigation ECU assembly certification).
Disconnecting and reconnecting the cable to the negative (-) terminal of the auxiliary battery, replacing the auxiliary battery, or recharging the auxiliary battery after being discharged.
Removing and installing or replacing the radio receiver assembly or navigation ECU assembly.
When replacing the telematics transceiver, make sure to replace it with a new one. (w/ Telematics Transceiver)
After replacing the radio receiver assembly, if "New software is not compatible with the system. Contact your dealer." is displayed on the multi-display assembly, update the software of the navigation ECU assembly.
After replacing the navigation ECU assembly , if "New software is not compatible with the system. Contact your dealer." is displayed on the multi-display assembly, update the software of the radio receiver assembly.
When replacing the integration control sub-assembly, always replace it with a new one. If an integration control sub-assembly which was installed to another vehicle is used, the following may occur:
A communication malfunction DTC may be stored.
The integration control sub-assembly may not operate normally.
If any of the following parts are replaced, refer to Work Procedure of When Replacing or Removing/Installing Parts.
Click hereGeneral>SETUP>WHEN REPLACING OR REMOVING/INSTALLING PARTS>WORK PROCEDURE
Telematics transceiver*
*: w/ Telematics Transceiver