DATA LIST
Using the GTS to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.
In the following table, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.
Read the Data List according to the display on the GTS.
| Tester Display | Measurement Item | Range | Normal Condition | Diagnostic Note |
|---|---|---|---|---|
| Passenger Buckle Switch | Front passenger seat belt buckle switch signal | Fastened or Not Fastened | Fastened: Front passenger seat belt fastened
Not Fastened: Front passenger seat belt not fastened |
w/o All Auto Control, w/o Occupant Classification System |
| Passenger Occupant Detection Switch | Occupant detection sensor signal | ON or OFF | ON: Front passenger seat occupied
OFF: Front passenger seat not occupied |
w/o Occupant Classification System |
| Rear Right Seat Buckle / Occupant Detection Warning Switch | Rear occupant detection sensor RH signal | ON or OFF | w/ Occupant Classification System:
ON: Rear RH seat belt fastened and occupied OFF: Rear RH seat belt not fastened and occupied w/o Occupant Classification System: ON: Rear RH seat occupied OFF: Rear RH seat not occupied |
- |
| Rear Left Seat Buckle / Occupant Detection Warning Switch | Rear occupant detection sensor LH signal | ON or OFF | w/ Occupant Classification System:
ON: Rear LH seat belt fastened and occupied OFF: Rear LH seat belt not fastened and occupied w/o Occupant Classification System: ON: Rear LH seat occupied OFF: Rear LH seat not occupied |
- |
| Rear Center Seat Buckle / Occupant Detection Warning Switch | Rear occupant detection sensor with center signal | ON or OFF | w/ Occupant Classification System:
ON: Rear center seat belt fastened and occupied OFF: Rear center seat belt not fastened and occupied w/o Occupant Classification System: ON: Rear center seat occupied OFF: Rear center seat not occupied |
- |
| Driver Seatbelt Warning Buzzer Function | Enables sounding ofthe driver seat belt warning buzzer | ON or OFF | Customized setting displayed | - |
| Passenger Seatbelt Warning Buzzer Function | Enables sounding ofthe front passenger seat belt warning buzzer | ON or OFF | Customized setting displayed | - |
| Rear Right Seatbelt Warning Buzzer Function | Function to sound the rear RH seat belt warning buzzer | ON or OFF | Customized value displayed | - |
| Rear Left Seatbelt Warning Buzzer Function | Function to sound the rear LH seat belt warning buzzer | ON or OFF | Customized value displayed | - |
| Rear Center Seatbelt Warning Buzzer Function | Function to sound the rear center seat belt warning buzzer | ON or OFF | Customized value displayed | - |
| Tester Display | Measurement Item | Range | Normal Condition | Diagnostic Note |
|---|---|---|---|---|
| D Seat Buckle SW | Driver seat belt buckle switch | ON or OFF | ON: Driver seat belt unfastened
OFF: Driver seat belt fastened |
w/o Occupant Classification System |
| Tester Display | Measurement Item | Range | Normal Condition | Diagnostic Note |
|---|---|---|---|---|
| Rear Right Seat Buckle Switch Status | Rear seat inner belt RH buckle signal | Buckle or Unbuckle | Buckle: Rear RH seat belt fastened
Unbuckle: Rear RH seat belt not fastened |
w/o Occupant Classification System |
| Rear Left Seat Buckle Switch Status | Rear seat inner belt LH buckle signal | Buckle or Unbuckle | Buckle: Rear LH seat belt fastened
Unbuckle: Rear LH seat belt not fastened |
w/o Occupant Classification System |
| Rear Center Seat Buckle Switch Status | Rear seat inner center belt buckle signal | Buckle or Unbuckle | Buckle: Rear center seat belt fastened
Unbuckle: Rear center seat belt not fastened |
w/o Occupant Classification System |
| Tester Display | Measurement Item | Range | Normal Condition | Diagnostic Note |
|---|---|---|---|---|
| Passenger Buckle SW | Front passenger buckle switch | Unset, Set or NG | Unset: Seat belt not fastened
Set: Seat belt fastened NG: Data is not determined |
w/ Occupant Classification System |
| Tester Display | Measurement Item | Range | Normal Condition | Diagnostic Note |
|---|---|---|---|---|
| Driver Seat Buckle Switch Status | Driver side buckle switch | Unknown, Unbuckle, Buckle or Malfunction | Unknown: Data is not determined
Unbuckle: Driver side seat belt unbuckle Buckle: Driver side seat belt buckle Malfunction: Driver side seat belt buckle circuit malfunction |
w/ Occupant Classification System |
| Passenger Seat Buckle Switch Status | Front passenger side buckle switch | Unknown, Unbuckle, Buckle or Malfunction | Unknown: Data is not determined
Unbuckle: Front passenger side seat belt unbuckle Buckle: Front passenger side seat belt buckle Malfunction: Front passenger side seat belt buckle circuit malfunction |
w/ Occupant Classification System |
ACTIVE TEST
Using the GTS to perform Active Tests allows relays, VSVs, actuators and other items to be operated without removing any parts. This non-intrusive functional inspection can be very useful because intermittent operation may be discovered before parts or wiring is disturbed. Performing Active Tests early in troubleshooting is one way to save diagnostic time. Data List information can be displayed while performing Active Tests.
Perform the Active Test according to the display on the GTS.
| Tester Display | Measurement Item | Control Range | Diagnostic Note |
|---|---|---|---|
| Driver Side Seat Belt Warning | Driver side seat belt warning light | OFF/ON | - |
| Passenger Side Seat Belt Warning | Front passenger side seat belt warning light | OFF/ON | Not applicable to this vehicle |
| Rear Seat Belt Warning | Rear seat belt warning light | OFF/ON | - |