1. FILLING INSTRUCTIONS WHEN ADDING COOLANT (TOYOTA GENUINE FC STACK COOLANT (Pre-mixed))
| *a | Coolant (Toyota Genuine FC Stack Coolant 50) Internal Volume (L) | *b | Natural injection |
| *c | FC stack coolant Amount Check + Fill | *d | Bleed Air + Fill |
| *e | Coolant (Toyota Genuine FC Stack Coolant 50) Total Volume:16.4 liters (17.3 US qts, 14.4 Imp. qts) | - | - |
Natural injection
With the ignition switch off, fill as much coolant (Toyota genuine FC stack coolant 50) as possible from the FC cooling water ion exchanger assembly and FC radiator reserve tank assembly.
FC stack coolant Amount Check + Fill
After performing natural filling, set the rotary valve to a 50% open position during the Active Test. This sets the mode to bleed air mode and the FC Stack Coolant amount check begins operating.
The FC Stack Coolant amount check function operates the water pump for approximately 1 minute after the ignition switch is turned on (READY) and then determines the FC Stack Coolant amount based on the water pump load.
If it is determined that the FC Stack Coolant amount is OK, READY-ON illuminates, the FC system starts and then the mode can transition to "bleed air + fill".
If it is determined that the FC Stack Coolant amount is NG, "FC System Malfunction" is displayed on the multi-information display and the FC Stack Coolant amount check stops.
The FC Stack Coolant amount check provides a simple function to bleed air when the water pump is operated for approximately 1 minute, and the FC Stack Coolant level will drop slightly. It will be necessary to repeatedly perform coolant (Toyota genuine FC stack coolant 50) filling and the FC Stack Coolant amount check until the FC Stack Coolant amount check determines that the amount is OK.
If the mode is not set to bleed air mode, the water pump will operate only for several seconds during the FC Stack Coolant amount check and simple air bleeding will not be as effective. The number of repetitions until the FC Stack Coolant amount check is OK will therefore increase.
During the FC Stack Coolant amount check, the check will be performed with power provided from the EV supply battery assembly. The FC system will not start.
Bleed Air + Fill
After READY-ON is illuminated and the FC system has started, fill coolant (Toyota genuine FC stack coolant 50) up to the MAX line in the FC radiator reserve tank assembly while performing air bleeding with the Utility and Active Test.