Home › BODY ELECTRICAL › NAVIGATION › NAVIGATION SYSTEM

NAVIGATION SYSTEM > Display does not Dim when Light Control Switch is Turned ON

for Preparation Click here


INSPECTION PROCEDURE

1.CHECK IMAGE QUALITY SETTING


    E124058E01
  1. Enter the display adjustment screen by pressing the "DISPLAY" switch.

  1. Turn the light control switch to the TAIL position.

  1. Check if "Day Mode" on the display is ON.

    OK:
    "Day Mode" is ON.



OK
TURN "DAY MODE" SETTING OFF
NG


2.CHECK VEHICLE SIGNAL (DISPLAY VEHICLE SIGNAL)


    I038223E04
  1. Enter the "Display Check" mode (Vehicle Signal Check Mode) (Click here).

  1. Cover the automatic light control sensor on the instrument panel with a cloth.

  1. Set the instrument panel light control to less than maximum (to activate the dimmer function that works when the light control switch is in the TAIL position).

  1. Check that the display changes between ON and OFF according to the light control switch operation.

    OK:
    Light Control Switch Condition
    Display Condition
    TAIL or ON
    DIM
    OFF
    BRIGHT

    HINT:
    The display is updated once per second. It is normal for the display to lag behind the actual switch operation.



NG
PROCEED TO NEXT INSPECTION PROCEDURE SHOWN IN PROBLEM SYMPTOMS TABLE
OK

REPLACE MULTI-DISPLAY