Home › BODY ELECTRICAL › NAVIGATION › NAVIGATION SYSTEM

NAVIGATION SYSTEM > Cursor or Map Rotates when Vehicle Stopped

for Preparation Click here


INSPECTION PROCEDURE

1.CHECK CONDITION


    E106418
  1. Check with the customer if the vehicle has been turned by a turntable at parking.

    OK:
    Vehicle has not been turned by turntable.

    HINT:
    If the power switch is turned to the ON (ACC or IG) position while the vehicle is being turned by a turntable, the system may store the angular velocity at this time. For this reason, the vehicle position cursor could deviate.



NG
TURN POWER SWITCH TO ON (IG) POSITION WHEN VEHICLE IS COMPLETELY STOPPED
OK

PROCEED TO NEXT INSPECTION PROCEDURE SHOWN IN PROBLEM SYMPTOMS TABLE