Home › BODY ELECTRICAL › LIGHTING › LIGHTING SYSTEM

LIGHTING SYSTEM > HOW TO PROCEED WITH TROUBLESHOOTING

for Preparation Click here


HINT:
  1. Use these procedures to troubleshoot the lighting system.
  2. *: Use the Techstream.



1.VEHICLE BROUGHT TO WORKSHOP

    NEXT


    2.INSPECT BATTERY VOLTAGE

      Standard voltage:
      11 to 14 V

      If the voltage is below 11 V, recharge or replace the battery before proceeding.

    NEXT


    3.INSPECT COMMUNICATION FUNCTION LARGE-SCALE MULTIPLEX COMMUNICATION SYSTEM (BEAN)*
    1. Use the Techstream to check if the Multiplex Communication System (MPX) is functioning normally.
      Result 
      Result
      Proceed to
      MPX DTC is not output
      A
      MPX DTC is output (Click here)
      B



    B.
    Go to MULTIPLEX COMMUNICATION SYSTEM
    A


    4.CHECK FOR DTC*
      Result 
      Result
      Proceed to
      DTC is not output
      A
      DTC is output (Click here)
      B


    B.
    Go to step 7
    A


    5.PROBLEM SYMPTOMS TABLE

      Result 
      Result
      Proceed to
      Fault is not listed in problem symptoms table
      A
      Fault is listed in problem symptoms table (Click here)
      B


    B.
    Go to step 7
    A


    6.OVERALL ANALYSIS AND TROUBLESHOOTING*
    1. Operation Check (Click here)

    2. Terminals of ECU (Click here)

    3. DATA LIST / ACTIVE TEST (Click here)


    NEXT


    7.REPAIR OR REPLACE

      NEXT


      8.CONFIRMATION TEST

        NEXT

        END