Home › BODY ELECTRICAL › NAVIGATION › NAVIGATION SYSTEM

NAVIGATION SYSTEM > Voice is not Recognized

for Preparation Click here


INSPECTION PROCEDURE

1.CHECK NAVIGATION SETTINGS


    I102019
  1. Enter the "Menu" screen by pressing the "MENU" switch.

  1. Select "Set up".



    I102025
  1. Check that "Voice Recognition Guidance" is not OFF.

    OK:
    Voice Recognition Guidance is not OFF.



NG
TURN VOICE RECOGNITION GUIDANCE "ON"
OK


2.CHECK MAP DISC


    I100152E12
  1. Check that the map disc is not deformed or cracked.

    OK:
    No deformations or cracks on map disc.



NG
REPLACE MAP DISC
OK


3.CHECK MAP DISC


    I100201E04
  1. Check for dirt on the map disc surface.

    OK:
    No dirt is on the map disc surface.

    NOTICE:
    Do not use a conventional record cleaner or anti-static preservative.

    HINT:
    If the disc is dirty, clean the disc by wiping the disc surface radially with a soft cloth.



NG
CLEAN MAP DISC
OK


4.CHECK MICROPHONE (NAVIGATION CHECK MODE)


    E125118E01
  1. Enter the "MICROPHONE & VOICE RECOGNITION CHECK" mode (Click here).

  1. When a voice is input into the microphone, check that the microphone input level meter changes according to the input voice.

  1. Push the recording switch and perform voice recording.

    HINT:
    The recording limit is 5 seconds.

  1. Check that the recording indicator remains on while recording and that the recorded voice is played normally without noise or distortion.

    OK:
    All check results are normal.



OK
REPLACE NAVIGATION ECU
NG


5.CHECK MICROPHONE (DISPLAY CHECK MODE)


    E125811E01
  1. Enter the "MICROPHONE & VOICE RECOGNITION CHECK" mode (Click here).

  1. When a voice is input into the microphone, check that the microphone input level meter changes according to the input voice.

  1. Push the recording switch and perform voice recording.

    HINT:
    The recording limit is 5 seconds.

  1. Check that the recording indicator remains on while recording and that the recorded voice is played normally without noise or distortion.

    OK:
    All check results are normal.



NG
PROCEED TO NEXT INSPECTION PROCEDURE SHOWN IN PROBLEM SYMPTOMS TABLE
OK

END