ENGINE IMMOBILISER SYSTEM (w/ Smart Key System) > DIAGNOSIS SYSTEM |
| DESCRIPTION |
The certification ECU controls vehicle's immobiliser system function. Immobiliser system data and the Diagnostic Trouble Codes (DTCs) can be read through the vehicle's Data Link Connector 3 (DLC3). In some cases, a malfunction may be occurring in the immobiliser system even though the security indicator light is off. When the system seems to be malfunctioning, use the Techstream to check for malfunctions and perform repairs.
| CHECK DLC3 |
![]() |
The vehicle's ECU uses ISO 15765-4 for communication protocol. The terminal arrangement of the DLC3 complies with SAE J1962 and matches the ISO 15765-4 format.
| Symbols (Terminal No.) | Terminal Description | Condition | Specified Condition |
| SIL (7) - SG (5) | Bus "+" line | During transmission | Pulse generation |
| CG (4) - Body ground | Chassis ground | Always | Below 1 Ω |
| SG (5) - Body ground | Signal ground | Always | Below 1 Ω |
| BAT (16) - Body ground | Battery positive | Always | 10 to 14 V |
| CANH (6) - CANL (14) | CAN bus line | Power switch off*
| 54 to 69 Ω |
| CANH (6) - CG (4) | HIGH-level CAN bus line | Power switch off*
| 200 Ω or higher |
| CANL (14) - CG (4) | LOW-level CAN bus line | Power switch off*
| 200 Ω or higher |
| CANH (6) - BAT (16) | HIGH-level CAN bus line | Power switch off*
| 6 kΩ or higher |
| CANL (14) - BAT (16) | LOW-level CAN bus line | Power switch off*
| 6 kΩ or higher |
Connect the cable of the Techstream to the DLC3, turn the power switch on (IG) and attempt to use the Techstream. If the screen displays a communication error message, a problem exists in the vehicle side or tester side.