Home › BODY ELECTRICAL › DOOR LOCK › POWER DOOR LOCK CONTROL SYSTEM

POWER DOOR LOCK CONTROL SYSTEM > DIAGNOSIS SYSTEM

for Preparation Click here



DESCRIPTION
The main body ECU controls the functions of the power door lock control system on the vehicle. Data of the power door lock control system and Diagnostic Trouble Code (DTCs) can read in the Data Link Connector 3 (DLC3) of the vehicle.
When the system seems to be malfunctioning, use the Techstream to check for a malfunction and perform repairs.

CHECK DLC3


    H100769E16
  1. The vehicle's ECU uses ISO 15765-4 for communication protocol. The terminal arrangement of the DLC3 complies with SAE J1962 and matches the ISO 15765-4 format.

    Symbols (Terminal No.)
    Terminal Description
    Condition
    Specified Condition
    SIL (7) - SG (5)
    Bus "+" line
    During transmission
    Pulse generation
    CG (4) - Body ground
    Chassis ground
    Always
    Below 1 Ω
    SG (5) - Body ground
    Signal ground
    Always
    Below 1 Ω
    BAT (16) - Body ground
    Battery positive
    Always
    10 to 14 V
    CANH (6) - CANL (14)
    CAN bus line
    Power switch off*
    54 to 69 Ω
    CANH (6) - CG (4)
    HIGH-level CAN bus line
    Power switch off*
    200 Ω or higher
    CANL (14) - CG (4)
    LOW-level CAN bus line
    Power switch off*
    200 Ω or higher
    CANH (6) - BAT (16)
    HIGH-level CAN bus line
    Power switch off*
    6 kΩ or higher
    CANL (14) - BAT (16)
    LOW-level CAN bus line
    Power switch off*
    6 kΩ or higher

    NOTICE:
    *: Before measuring the resistance, leave the vehicle as is for at least 1 minute and do not operate the Ignition switch, any other switches or the doors.

    If the result is not as specified, the DLC3 may have a malfunction. Repair or replace the harness and connector.

  2. Connect the cable of the Techstream to the DLC3, turn the power switch on (IG) and attempt to use the Techstream. If the screen displays a communication error message, a problem exists in the vehicle side or tester side.

    HINT:
    1. If communication is normal when the tool is connected to another vehicle, inspect the DLC3 on the original vehicle.
    1. If communication is still impossible when the tool is connected to another vehicle, the problem is probably in the tool itself. Consult the Service Department listed in the tool's instruction manual.