DTC B1247 Tire Pressure Monitor Receiver Communication Stop |
| DTC No. | DTC Detection Condition | Trouble Area |
| B1247 | Tire pressure monitor receiver communication stops |
|

| 1.INSPECT FUSE (ECU-IG) |
Remove the ECU-IG fuse from the driver side junction block.
Measure the resistance of the fuse.
|
| ||||
| OK | |
| 2.CHECK WIRE HARNESS (TIRE PRESSURE WARNING ECU - BATTERY AND BODY GROUND) |
![]() |
Disconnect the T11 ECU connector.
Turn the power switch ON (IG).
Measure the voltage and resistance of the wire harness side connector.
| Tester Connection | Condition | Specified Condition |
| T11-1 (IG) - Body ground | Power switch ON (IG) | 10 to 14 V |
| Tester Connection | Specified Condition |
| T11-7 (GND) - Body ground | Below 1 Ω |
|
| ||||
| OK | |
| 3.CHECK RESISTANCE OF COMMUNICATION LINE |


Disconnect the T11, S11*1 and T4*2 ECU connectors.
Disconnect the C10 meter connector.
Measure the resistance of the wire harness side connector.
| Tester Connection | Specified Condition |
| T11-6 (MPX1) - S11-32 (MPX2)*1 | Below 1 Ω |
| T11-6 (MPX1) - T4-19 (MPX1)*2 | Below 1 Ω |
| T11-12 (MPX2) - C10-24 (MPX+) | Below 1 Ω |
| Result | Proceed to |
| Both are OK | A |
| One is OK | B |
| Both are NG | C |
|
| ||||
|
| ||||
| A | ||
| ||