AIRBAG SYSTEM > DIAGNOSIS SYSTEM |
| DESCRIPTION |
| CHECK DLC3 |
![]() |
The ECU uses ISO 15765-4 for communication. The terminal arrangement of the DLC3 complies with SAE J1962 and matches the ISO 15765-4 format.
| Symbols (Terminal No.) | Terminal Description | Condition | Specified Condition |
| SIL (7) - SG (5) | Bus "+" line | During transmission | Pulse generation |
| CG (4) - Body ground | Chassis ground | Always | Below 1 Ω |
| SG (5) - Body ground | Signal ground | Always | Below 1 Ω |
| BAT (16) - Body ground | Battery positive | Always | 11 to 14 V |
| CANH (6) - CANL (14) | CAN bus line | Power switch is OFF* | 54 to 69 Ω |
| CANH (6) - Battery positive | HIGH-level CAN bus line | Power switch is OFF* | 1 kΩ or more |
| CANH (6) - CG (4) | HIGH-level CAN bus line | Power switch is OFF* | 1 kΩ or more |
| CANL (14) - Battery positive | LOW-level CAN bus line | Power switch is OFF* | 1 MΩ or more |
| CANL (14) - CG (4) | LOW-level CAN bus line | Power switch is OFF* | 1 MΩ or more |
| SYMPTOM SIMULATION |
![]() |
Vibration method: When vibration seems to be the major cause.
Slightly vibrate the part of the sensor considered to be the problem cause with your fingers and check whether the malfunction occurs.
Slightly shake the connector vertically and horizontally.
Slightly shake the wire harness vertically and horizontally.
The connector joint and fulcrum of the vibration are the major areas to be checked thoroughly.
| FUNCTION OF SRS WARNING LIGHT |
Primary check.
Turn the power switch OFF. Wait for at least 2 seconds, then turn the power switch ON (IG). The SRS warning light comes on for approximately 6 seconds and the diagnosis of the airbag system (including the seat belt pretensioners) is performed.
Constant check.
After the primary check, the center airbag sensor constantly monitors the airbag system for trouble.
Review.
When the airbag system is normal:
The SRS warning light comes on only during the primary check period (for approximately 6 seconds after the power switch is turned ON (IG)).
When the airbag system has trouble:
| SRS WARNING LIGHT CHECK |
![]() |
Turn the power switch ON (IG), and check that the SRS warning light comes on for approximately 6 seconds (primary check).
Check that the SRS warning light goes off approximately 6 seconds after the power switch is turned ON (IG) (constant check).
| ACTIVATION PREVENTION MECHANISM |
FUNCTION OF ACTIVATION PREVENTION MECHANISM
An activation prevention mechanism is built into the connector on the center airbag sensor side of the airbag system squib circuit to prevent accidental airbag activation.
This mechanism closes the circuit when the connector is disconnected by bringing the short spring into contact with the terminals and shutting off external electricity to prevent accidental airbag activation.
RELEASE METHOD OF ACTIVATION PREVENTION MECHANISM
To release the activation prevention mechanism, insert a piece of paper with the same thickness as the male terminal (approximately 0.5 mm (0.020 in.)) between the terminals and the short spring to break the connection.
Refer to the illustrations below concerning connectors utilizing the activation prevention mechanism and its release method.


