Home › RESTRAINTS › SUPPLEMENTAL RESTRAINT SYSTEM › AIRBAG SYSTEM

AIRBAG SYSTEM > CHECK MODE PROCEDURE

for Preparation Click here



CHECK MODE (SIGNAL CHECK): DTC CHECK
  1. Connect the Techstream to the DLC3.

  2. Turn the power switch ON (IG).

  3. Select the SIGNAL CHECK, and proceed to check with the Techstream.

    NOTICE:
    Select the SIGNAL CHECK from the DTC CHECK screen displayed on the Techstream to clear the output DTCs (both present and past).

    HINT:
    1. DTCs can be detected more sensitively in check mode than in normal diagnosis mode.
    2. Perform the check mode inspection when a malfunction in each squib circuit is suspected even after the normal system code is output through the normal diagnosis mode inspection.