Home › SUSPENSION & AXLE › TIRE AND WHEEL › TIRE PRESSURE WARNING SYSTEM

TIRE PRESSURE WARNING SYSTEM > TERMINALS OF ECU

for Preparation Click here



CHECK TIRE PRESSURE WARNING ECU

F100629E05

  1. Measure the voltage of the connector.

    Symbols (Terminal No.)
    Wiring Color
    Terminal Description
    Condition
    Specified Condition
    IG (T11-1) - GND (T11-7)
    B - W-B
    IG power source
    Power switch ON (IG)
    10 to 16 V
    CLSW (T11-2) - GND (T11-7)
    GR - W-B
    Tire pressure warning reset switch
    Power switch ON (IG), Tire pressure warning reset switch on
    8 to 15 V
    CLSW (T11-2) - GND (T11-7)
    GR - W-B
    Tire pressure warning reset switch
    Power switch ON (IG), Tire pressure warning reset switch off
    Below 1.5 V
    GND2 (T11-4) - GND (T11-7)
    G - W-B
    Tire pressure warning antenna and receiver ground
    Always
    Below 1 Ω
    MPX1 (T11-6) - GND (T11-7)
    W - W-B
    Multiplex communication line
    Power switch ON (IG)
    10 to 16 V
    RDA (T11-9) - GND (T11-7)
    B - W-B
    Tire pressure warning antenna and receiver signal
    Power switch ON (IG), when the tire pressure warning antenna and receiver is not connected
    9 to 16 V
    RF5V (T11-10) - GND (T11-7)
    R - W-B
    Tire pressure warning antenna and receiver power source
    Power switch ON (IG)
    4.5 to 5.5 V
    MPX2 (T11-12) - GND (T11-7)
    B - W-B
    Multiplex communication line
    Power switch ON (IG)
    10 to 16 V
    If the result is not as specified, the ECU may have a malfunction.