Home › RESTRAINTS › SUPPLEMENTAL RESTRAINT SYSTEM › AIRBAG SYSTEM

AIRBAG SYSTEM > SRS Warning Light does not Come ON

for Preparation Click here


DESCRIPTION

The SRS warning light is located on the combination meter. When the power switch is turned from OFF to ON (IG), the SRS warning light illuminates. If the SRS is normal, the SRS warning light turns off automatically after approximately 6 seconds. If there is a malfunction in the SRS, the SRS warning light remains illuminated even after approximately 6 seconds have passed. When terminals TC and CG of the DLC3 are connected, the DTCs are communicated through SRS warning light blinking patterns.

WIRING DIAGRAM


C130816E01


INSPECTION PROCEDURE

1.CHECK CONNECTION OF CONNECTORS
  1. Disconnect the cable from the negative (-) battery terminal, and wait for at least 90 seconds.

  1. Check that the connectors are properly connected to the center airbag sensor and combination meter.

    OK:
    Connectors are connected.



NG
CONNECT CONNECTORS
OK


2.CHECK COMBINATION METER ASSEMBLY
I102401E01
  1. Disconnect the C10 meter connector.

  1. Turn the power switch ON (IG).

  1. Measure the voltage of the wire harness side connector.

    Standard voltage:
    Tester Connection
    Specified Condition
    C10-21 - Body ground
    8 to 14 V



NG
REPAIR OR REPLACE HARNESS AND CONNECTOR
OK


3.CHECK SRS WARNING LIGHT (OPERATION)
  1. Disconnect the A18 sensor connector with the C10 meter connector connected.

  1. Turn the power switch ON (IG).

  1. Check that the warning light illuminates for 6 seconds after turning the power switch ON (IG).

    OK:
    Warning light illuminates for 6 seconds after turning power switch ON (IG).



NG
REPLACE COMBINATION METER ASSEMBLY
OK


4.REPLACE CENTER AIRBAG SENSOR ASSEMBLY
  1. Replace the center airbag sensor.

  1. Check that the SRS warning light illuminates normally.

    OK:
    SRS warning light illuminates normally.



NG
REPLACE COMBINATION METER ASSEMBLY
OK

END